I mentioned in the " Projects" area that I am using the front air dam off a Buick regal on my 77 Pinto. I need to make a correction on that statement. It is not a Buick Regal but a 88-89 Chevy Celebrity. I happened to see this dam on a car that my friend was towing off and asked to have it. I found that the louver was an excellant match to the stock grill on my Pinto. The front width was good for a fitup right to the underside of the bumper with the fabrication of some small brackets. The only thing that I had to cut was the wrap arounds. They needed to be a little shorter. Then the back of the wrap arounds screwed right into the front/lower wheel wells. There is a space that could be filled on the front side body but I never did. Also there is about a 1/2 inch flat that runs along the bottom of this spoiler which enabled me to screw a 2 inch piece of sheet metal to to extend the dam downward. I have had mine on there since 92. I will post better pics of this down the road a bit. Mine is off right now cause I am doing the radiator thing.