Current Classifieds

74 Pinto Hub Caps & Trim Rings

Date: 02/28/2018 09:37 am
74 Pinto Rear Side Lights

Date: 02/18/2017 05:47 pm
78 windshield trim
Date: 02/01/2020 08:46 am
Needed, 2.0 or 2.3 motors
Date: 09/30/2018 07:47 pm
Need right door for pinto or bobcat 1977 to 1980 station wagon
Date: 08/03/2018 09:19 am
1973 FORD PINTO HOOD "F O R D" LETTERS
Date: 02/11/2020 12:09 am
73 2.0 Timing Crank Gear & Woodruff key WANTED
Date: 09/01/2017 07:52 am
72 pinto wagon. 1 owner. 67K miles
Date: 10/14/2019 08:24 pm
'76 Wagon Driver Side Rear Interior Panel
Date: 11/11/2019 04:49 pm
1977 Pinto Cruizin Wagon

Date: 08/07/2023 02:52 pm
hubcaps

Date: 10/31/2018 12:04 pm
Odds and Ends 1976-77 Pinto Wagon

Date: 07/17/2019 05:23 pm

Author Topic: is this correct part # ?  (Read 1243 times)

0 Members and 1 Guest are viewing this topic.

Offline dmsteen

  • Pinto Full Member
  • ***
  • Posts: 130
  • FeedBack: +0/-0
  • Gender: Male

  • Total Badges: 2
    Badges: (View All)
    Topic Starter Fifth year Anniversary
is this correct part # ?
« on: April 02, 2013, 05:14:56 PM »
I have part # D5FZ-7329164A and 5A listed for L @ R rear wheel moldings for 77-80 wagon.i have been told that only 79 @ 80 are the same. does anybody know for sure ? it might make it a little easier to find a pair cause it seems impossible to find a set in any condition
 
thanx dave

Offline 289Wagon

  • Pinto Full Member
  • ***
  • Posts: 234
  • FeedBack: +29/-3
  • Gender: Male

  • Total Badges: 3
    Badges: (View All)
    Topic Starter Signature Fifth year Anniversary
Re: is this correct part # ?
« Reply #1 on: April 03, 2013, 06:22:16 AM »
I sent this info to you in a PM awhile back, but I never got a reply.
 The rears are the same from '75 (with the 1-1/2 wide molding) thru '80.
 It was the front that changed in '79.
Still living the dream...In a points & condenser world.

Offline dmsteen

  • Pinto Full Member
  • ***
  • Posts: 130
  • FeedBack: +0/-0
  • Gender: Male

  • Total Badges: 2
    Badges: (View All)
    Topic Starter Fifth year Anniversary
Re: is this correct part # ?
« Reply #2 on: April 03, 2013, 03:51:16 PM »
I never got the pm  but thanx for the info !! this will help a lot !!