Current Classifieds

Right side strut mount for 3rd door 1979 runabout
Date: 10/04/2019 08:43 pm
1976 Pinto

Date: 10/24/2017 02:00 pm
t-5 2.3 trans and new flywheel cluch and pressure plate though out bearing for sale
Date: 09/12/2018 04:07 pm
Bumper Guards
Date: 03/28/2017 09:27 pm
Clutch pedal needed
Date: 01/11/2024 06:31 am
Front sway bar frame brackets
Date: 07/13/2017 01:05 am
1977 Pinto Cruizin Wagon

Date: 04/11/2024 04:13 pm
parting out 1975 & 80 pintos
Date: 10/31/2018 12:00 pm
2.3 bellhousing stick
Date: 07/24/2019 06:50 pm
Front and rear seats for a 1976 Pinto Sedan
Date: 05/18/2020 10:22 pm
Early 2.0 engines
Date: 05/09/2018 12:45 pm
Wanted 73 pinto squire wagon
Date: 05/09/2020 11:59 am

Author Topic: Correct Tranny Fluid for a 1980 C-4  (Read 8905 times)

0 Members and 1 Guest are viewing this topic.

Offline rob289c

  • Pinto Sr. Member
  • ****
  • Posts: 381
  • FeedBack: +7/-0
  • Gender: Male
  • Another Pinto Driver

  • Total Badges: 3
    Badges: (View All)
    Fifth year Anniversary Signature Topic Starter
Correct Tranny Fluid for a 1980 C-4
« on: October 31, 2023, 01:15:09 PM »
I know the older C-4's use Type F, but at some point in the late 70's Ford started using Dex II.  The 1980 Owner's Manual recommends Dex II.  I am told Type F would provide crisper shifts.  I think Dex II is now Dex 6 and supposedly backward compatible.  I have both Type F and Dex-Merc in stock.  I think Dex-Merc is closest to what the owner's manual suggests.  See attached. 

What are you all using in your C-4's, specifically if you have a 1980 version?  What is the scuttlebutt on pros and cons of both fluids?  I have no history on this tranny, in fact I don't know if it has been rebuilt at some point in the past, or if it even works.   

What would you do if it was yours?  Last year I drained the old fluid, cleaned the pan, and installed a new filter.  By next year I plan to run and hopefully drive it so I want to be prepared with and use the correct fluid. 
rob289c

Offline davidpinto

  • PCCA Charter Member
  • Pinto Full Member
  • *
  • Posts: 108
  • FeedBack: +19/-0
  • Gender: Male
  • pinto enthusiast

  • Total Badges: 4
    Badges: (View All)
    Photographer Topic Starter Signature Poll Voter
Re: Correct Tranny Fluid for a 1980 C-4
« Reply #1 on: October 31, 2023, 06:53:01 PM »
79 AND EARLIER C4s USE TYPE F, IN 1980 THEY WENT TO DEXRON .WHICH I RUN IN MY 80 MODEL.DEXRON III AND DEXRON-MERCON ARE THE SAME.
D BARHAM

Offline rob289c

  • Pinto Sr. Member
  • ****
  • Posts: 381
  • FeedBack: +7/-0
  • Gender: Male
  • Another Pinto Driver

  • Total Badges: 3
    Badges: (View All)
    Fifth year Anniversary Signature Topic Starter
Re: Correct Tranny Fluid for a 1980 C-4
« Reply #2 on: November 01, 2023, 06:14:20 AM »
Thank you for that answer.  I will use up the Dex/Merc I have in stock.  I think the only other think I have that uses it is the transfer case in my '03 Ranger. 
rob289c