Current Classifieds

1977 Pinto Cruising Wagon FOR SALE

Date: 08/20/2017 01:34 pm
Clutch Pedals for 75to 80 Pinto
Date: 09/21/2018 11:35 am
72 pinto wagon. 1 owner. 67K miles
Date: 10/14/2019 08:24 pm
V8 rear end
Date: 04/12/2018 10:57 am
1978 ford pinto carb
Date: 02/04/2018 06:09 pm
2.3 carb intake

Date: 07/15/2020 09:25 pm
Pinto Watch
Date: 06/22/2019 07:16 pm
Looking for Radiator and gas tank
Date: 10/24/2018 07:41 am
WTB: Ford Type 9 5spd Transmission
Date: 03/18/2020 01:30 am
2.3 turbo intake (lower)

Date: 07/15/2020 09:29 pm
1977 Left Side quarter panel
Date: 06/10/2019 04:16 pm
WANTED: Dash, fender, hood, gauge bezel '73 Wagon
Date: 01/18/2017 05:35 pm

Author Topic: Correct Tranny Fluid for a 1980 C-4  (Read 8910 times)

0 Members and 1 Guest are viewing this topic.

Offline rob289c

  • Pinto Sr. Member
  • ****
  • Posts: 381
  • FeedBack: +7/-0
  • Gender: Male
  • Another Pinto Driver

  • Total Badges: 3
    Badges: (View All)
    Fifth year Anniversary Signature Topic Starter
Correct Tranny Fluid for a 1980 C-4
« on: October 31, 2023, 01:15:09 PM »
I know the older C-4's use Type F, but at some point in the late 70's Ford started using Dex II.  The 1980 Owner's Manual recommends Dex II.  I am told Type F would provide crisper shifts.  I think Dex II is now Dex 6 and supposedly backward compatible.  I have both Type F and Dex-Merc in stock.  I think Dex-Merc is closest to what the owner's manual suggests.  See attached. 

What are you all using in your C-4's, specifically if you have a 1980 version?  What is the scuttlebutt on pros and cons of both fluids?  I have no history on this tranny, in fact I don't know if it has been rebuilt at some point in the past, or if it even works.   

What would you do if it was yours?  Last year I drained the old fluid, cleaned the pan, and installed a new filter.  By next year I plan to run and hopefully drive it so I want to be prepared with and use the correct fluid. 
rob289c

Offline davidpinto

  • PCCA Charter Member
  • Pinto Full Member
  • *
  • Posts: 108
  • FeedBack: +19/-0
  • Gender: Male
  • pinto enthusiast

  • Total Badges: 4
    Badges: (View All)
    Photographer Topic Starter Signature Poll Voter
Re: Correct Tranny Fluid for a 1980 C-4
« Reply #1 on: October 31, 2023, 06:53:01 PM »
79 AND EARLIER C4s USE TYPE F, IN 1980 THEY WENT TO DEXRON .WHICH I RUN IN MY 80 MODEL.DEXRON III AND DEXRON-MERCON ARE THE SAME.
D BARHAM

Offline rob289c

  • Pinto Sr. Member
  • ****
  • Posts: 381
  • FeedBack: +7/-0
  • Gender: Male
  • Another Pinto Driver

  • Total Badges: 3
    Badges: (View All)
    Fifth year Anniversary Signature Topic Starter
Re: Correct Tranny Fluid for a 1980 C-4
« Reply #2 on: November 01, 2023, 06:14:20 AM »
Thank you for that answer.  I will use up the Dex/Merc I have in stock.  I think the only other think I have that uses it is the transfer case in my '03 Ranger. 
rob289c