Current Classifieds

99' 2.5l lima cylinder head

Date: 01/13/2017 01:56 am
Need Mustang II Manual Transmission Mount
Date: 04/21/2017 02:03 pm
hubcaps

Date: 10/31/2018 12:04 pm
Built and Injected early 2000cc Engine

Date: 04/10/2017 07:30 pm
Wanted Postal Pinto
Date: 09/26/2019 05:31 pm
Wanted - Offenhauser intake for 2.8l (6097DP)
Date: 01/28/2019 05:15 pm
Bellhousing for C4 to 2.0 litre pinto
Date: 01/30/2017 01:48 pm
1974 points distributor for 2.3l
Date: 07/04/2022 07:55 pm
1978 FORD PINTO PONY FOR SALE 17.000 MILES !!!!!!!!!!!!

Date: 06/25/2021 12:59 am
72 pinto drag car

Date: 07/08/2017 08:53 pm
78 wagon instrument y
Date: 04/30/2018 07:41 pm
Tire needed p185/80r13
Date: 12/31/2017 09:08 pm

« previous next »
Pages: [1]   Go Down

Author Topic: 4 speed gear oil change  (Read 10028 times)

0 Members and 1 Guest are viewing this topic.

Offline Creedmoor

  • Pinto Member
  • **
  • Posts: 13
  • FeedBack: +0/-0
  • Another Pinto Driver

    • Total Badges: 2
    Badges: (View All)
    Topic Starter Mobile User
4 speed gear oil change
« on: June 28, 2023, 02:37:01 PM »
1980 Pony, 2.3, 4 speed manual. Wanted to change the lube in the gearbox with some fresh GL-4. However, searching the forum gave mixed results on wether or not there is a drain plug on the trans. So, do these things have drain and fill plugs or not?  If no, besides dropping the trans, are there any methods to perform a lube change?  If it has a fill plug, is it feasible to use a suction pump to drain it?  Appreciate any advice.
Logged

Offline rob289c

  • Pinto Sr. Member
  • ****
  • Posts: 383
  • FeedBack: +7/-0
  • Gender: Male
  • Another Pinto Driver

    • Total Badges: 3
    Badges: (View All)
    Fifth year Anniversary Signature Topic Starter
Re: 4 speed gear oil change
« Reply #1 on: June 28, 2023, 07:50:32 PM »
In 1984 I changed a clutch in a 77 with a 4-speed.  I don't recall whether or not there were drain and fill plugs, and because I don't remember, that leads me to believe that there were plugs.  If there weren't, that would have been an oddity and I think I would have remembered that.  The 1982 EXP with a 4-speed had drain and fill plugs.  Granted, it was a transaxle (FWD), so I am 99.9% sure your 80 4-speed will have drain and fil plugs.
Logged
rob289c

Offline ponyboy

  • Pinto Member
  • **
  • Posts: 67
  • FeedBack: +2/-0
  • Gender: Male
  • '73 woodgrain wagon

    • Total Badges: 5
    Badges: (View All)
    Poll Voter Topic Starter Windows User Tenth year Anniversary Fifth year Anniversary
Re: 4 speed gear oil change
« Reply #2 on: August 27, 2023, 10:22:33 AM »
My 1973 2.0L 4 speed does not have a drain plug, but strangely enough it does have two plugs, both on the left side. The BOTTOM one is the fill plug. I don't know what the top one is for. You can pump some of it out, but there is no way to get the sediment on the bottom out, and to me that's the important part. I found a lot of it in the rear axle, and flushed it out with brake cleaner. I don't think these cars were meant to be serviced. There are no grease fittings on the ball joints or tie rod ends.
Logged
Pages: [1]   Go Up
« previous next »