Current Classifieds

Holley 2305 progressive 2 bbl carb 350cfm

Date: 10/11/2019 11:13 am
Many Parts Listed Below
Date: 04/20/2018 11:15 am
 1971 ford pinto items for sale

Date: 08/03/2017 07:40 pm
t-5 2.3 trans and new flywheel cluch and pressure plate though out bearing for sale
Date: 09/12/2018 04:07 pm
Wanted - Offenhauser intake for 2.8l (6097DP)
Date: 01/28/2019 05:15 pm
Wagon rear quarters
Date: 06/17/2020 03:32 pm
6.6.75 carrier
Date: 02/14/2018 06:47 am
78 wagon instrument y
Date: 04/30/2018 07:41 pm
Need Clutch & Brake Pedal
Date: 12/23/2016 06:16 pm
1971 Pinto Runabout turn key driver

Date: 07/01/2019 12:23 pm
Wiring diagram Ignition switch 72 2.0 4 speed pinto wagon
Date: 12/31/2017 11:14 pm
convert to stick
Date: 05/19/2018 09:26 pm

« previous next »
Pages: [1]   Go Down

Author Topic: 4 speed gear oil change  (Read 9994 times)

0 Members and 1 Guest are viewing this topic.

Offline Creedmoor

  • Pinto Member
  • **
  • Posts: 13
  • FeedBack: +0/-0
  • Another Pinto Driver

    • Total Badges: 2
    Badges: (View All)
    Topic Starter Mobile User
4 speed gear oil change
« on: June 28, 2023, 02:37:01 PM »
1980 Pony, 2.3, 4 speed manual. Wanted to change the lube in the gearbox with some fresh GL-4. However, searching the forum gave mixed results on wether or not there is a drain plug on the trans. So, do these things have drain and fill plugs or not?  If no, besides dropping the trans, are there any methods to perform a lube change?  If it has a fill plug, is it feasible to use a suction pump to drain it?  Appreciate any advice.
Logged

Offline rob289c

  • Pinto Sr. Member
  • ****
  • Posts: 381
  • FeedBack: +7/-0
  • Gender: Male
  • Another Pinto Driver

    • Total Badges: 3
    Badges: (View All)
    Fifth year Anniversary Signature Topic Starter
Re: 4 speed gear oil change
« Reply #1 on: June 28, 2023, 07:50:32 PM »
In 1984 I changed a clutch in a 77 with a 4-speed.  I don't recall whether or not there were drain and fill plugs, and because I don't remember, that leads me to believe that there were plugs.  If there weren't, that would have been an oddity and I think I would have remembered that.  The 1982 EXP with a 4-speed had drain and fill plugs.  Granted, it was a transaxle (FWD), so I am 99.9% sure your 80 4-speed will have drain and fil plugs.
Logged
rob289c

Offline ponyboy

  • Pinto Member
  • **
  • Posts: 67
  • FeedBack: +2/-0
  • Gender: Male
  • '73 woodgrain wagon

    • Total Badges: 5
    Badges: (View All)
    Poll Voter Topic Starter Windows User Tenth year Anniversary Fifth year Anniversary
Re: 4 speed gear oil change
« Reply #2 on: August 27, 2023, 10:22:33 AM »
My 1973 2.0L 4 speed does not have a drain plug, but strangely enough it does have two plugs, both on the left side. The BOTTOM one is the fill plug. I don't know what the top one is for. You can pump some of it out, but there is no way to get the sediment on the bottom out, and to me that's the important part. I found a lot of it in the rear axle, and flushed it out with brake cleaner. I don't think these cars were meant to be serviced. There are no grease fittings on the ball joints or tie rod ends.
Logged
Pages: [1]   Go Up
« previous next »