Current Classifieds

Looking for fan shroud for 72' Pinto 1.6
Date: 04/13/2017 04:56 am
Looking for 1.6 exhaust manifold heat shield, front license plate bracket
Date: 11/04/2018 02:34 am
1977 pinto rear bumper
Date: 04/19/2021 11:57 am
Front sway bar

Date: 07/23/2018 08:19 pm
1974 Ford Pinto Squire Wagon

Date: 05/30/2020 01:51 pm
71-73 Rear valance panel
Date: 01/14/2021 06:54 pm
Automatic transmission
Date: 02/13/2021 02:52 pm
1973 Ford Pinto, Shift linkage for a/t and cross member
Date: 02/25/2017 08:45 pm
Wanted 71-73 Pinto grill
Date: 03/09/2019 10:45 pm
need intake for oval port 2.3l
Date: 08/22/2018 09:23 am
I'm looking for a 78 or older Pinto near Alberta
Date: 08/13/2021 10:39 am
Weather Strip, Muffler, Splash Shields

Date: 02/21/2022 11:11 pm

« previous next »
Pages: [1]   Go Down

Author Topic: 4 speed gear oil change  (Read 9940 times)

0 Members and 1 Guest are viewing this topic.

Offline Creedmoor

  • Pinto Member
  • **
  • Posts: 13
  • FeedBack: +0/-0
  • Another Pinto Driver

    • Total Badges: 2
    Badges: (View All)
    Topic Starter Mobile User
4 speed gear oil change
« on: June 28, 2023, 02:37:01 PM »
1980 Pony, 2.3, 4 speed manual. Wanted to change the lube in the gearbox with some fresh GL-4. However, searching the forum gave mixed results on wether or not there is a drain plug on the trans. So, do these things have drain and fill plugs or not?  If no, besides dropping the trans, are there any methods to perform a lube change?  If it has a fill plug, is it feasible to use a suction pump to drain it?  Appreciate any advice.
Logged

Offline rob289c

  • Pinto Sr. Member
  • ****
  • Posts: 380
  • FeedBack: +7/-0
  • Gender: Male
  • Another Pinto Driver

    • Total Badges: 3
    Badges: (View All)
    Fifth year Anniversary Signature Topic Starter
Re: 4 speed gear oil change
« Reply #1 on: June 28, 2023, 07:50:32 PM »
In 1984 I changed a clutch in a 77 with a 4-speed.  I don't recall whether or not there were drain and fill plugs, and because I don't remember, that leads me to believe that there were plugs.  If there weren't, that would have been an oddity and I think I would have remembered that.  The 1982 EXP with a 4-speed had drain and fill plugs.  Granted, it was a transaxle (FWD), so I am 99.9% sure your 80 4-speed will have drain and fil plugs.
Logged
rob289c

Offline ponyboy

  • Pinto Member
  • **
  • Posts: 67
  • FeedBack: +2/-0
  • Gender: Male
  • '73 woodgrain wagon

    • Total Badges: 5
    Badges: (View All)
    Poll Voter Topic Starter Windows User Tenth year Anniversary Fifth year Anniversary
Re: 4 speed gear oil change
« Reply #2 on: August 27, 2023, 10:22:33 AM »
My 1973 2.0L 4 speed does not have a drain plug, but strangely enough it does have two plugs, both on the left side. The BOTTOM one is the fill plug. I don't know what the top one is for. You can pump some of it out, but there is no way to get the sediment on the bottom out, and to me that's the important part. I found a lot of it in the rear axle, and flushed it out with brake cleaner. I don't think these cars were meant to be serviced. There are no grease fittings on the ball joints or tie rod ends.
Logged
Pages: [1]   Go Up
« previous next »