Current Classifieds

Tire needed p185/80r13
Date: 12/31/2017 09:08 pm
SEARCHING HOPELESSLY
Date: 02/02/2017 07:21 am
EARLY PINTO CLUTCH PEDAL ASSEMBLY
Date: 02/14/2019 06:27 pm
71/72 Pinto front end bushing kit
Date: 02/05/2017 09:45 am
'72 Runabout Drivers Side Door Hinge Set
Date: 12/15/2018 02:21 am
1976 Ford Pinto

Date: 07/16/2019 02:51 am
Need 76' coupe rear Glass and Front Grille
Date: 07/20/2017 01:23 am
6.6.75 carrier
Date: 02/14/2018 06:47 am
1973 Pinto Wagon

Date: 05/06/2022 05:13 pm
Pinto for sale

Date: 04/19/2017 10:15 am
Looking for a 1980 windshield
Date: 07/30/2020 04:51 pm
1978 need kick panels and rear hatch struts and upper and lower mounts
Date: 11/29/2018 10:26 am

« previous next »
Pages: [1]   Go Down

Author Topic: 4 speed gear oil change  (Read 10130 times)

0 Members and 1 Guest are viewing this topic.

Offline Creedmoor

  • Pinto Member
  • **
  • Posts: 13
  • FeedBack: +0/-0
  • Another Pinto Driver

    • Total Badges: 2
    Badges: (View All)
    Topic Starter Mobile User
4 speed gear oil change
« on: June 28, 2023, 02:37:01 PM »
1980 Pony, 2.3, 4 speed manual. Wanted to change the lube in the gearbox with some fresh GL-4. However, searching the forum gave mixed results on wether or not there is a drain plug on the trans. So, do these things have drain and fill plugs or not?  If no, besides dropping the trans, are there any methods to perform a lube change?  If it has a fill plug, is it feasible to use a suction pump to drain it?  Appreciate any advice.
Logged

Offline rob289c

  • Pinto Sr. Member
  • ****
  • Posts: 387
  • FeedBack: +7/-0
  • Gender: Male
  • Another Pinto Driver

    • Total Badges: 3
    Badges: (View All)
    Fifth year Anniversary Signature Topic Starter
Re: 4 speed gear oil change
« Reply #1 on: June 28, 2023, 07:50:32 PM »
In 1984 I changed a clutch in a 77 with a 4-speed.  I don't recall whether or not there were drain and fill plugs, and because I don't remember, that leads me to believe that there were plugs.  If there weren't, that would have been an oddity and I think I would have remembered that.  The 1982 EXP with a 4-speed had drain and fill plugs.  Granted, it was a transaxle (FWD), so I am 99.9% sure your 80 4-speed will have drain and fil plugs.
Logged
rob289c

Offline ponyboy

  • Pinto Member
  • **
  • Posts: 69
  • FeedBack: +2/-0
  • Gender: Male
  • '73 woodgrain wagon

    • Total Badges: 5
    Badges: (View All)
    Poll Voter Topic Starter Windows User Tenth year Anniversary Fifth year Anniversary
Re: 4 speed gear oil change
« Reply #2 on: August 27, 2023, 10:22:33 AM »
My 1973 2.0L 4 speed does not have a drain plug, but strangely enough it does have two plugs, both on the left side. The BOTTOM one is the fill plug. I don't know what the top one is for. You can pump some of it out, but there is no way to get the sediment on the bottom out, and to me that's the important part. I found a lot of it in the rear axle, and flushed it out with brake cleaner. I don't think these cars were meant to be serviced. There are no grease fittings on the ball joints or tie rod ends.
Logged
Pages: [1]   Go Up
« previous next »