Current Classifieds

1971 Pinto Parting out

Date: 07/06/2018 01:11 pm
2 Station Wagons for sale
Date: 04/20/2018 11:10 am
1978 fuel sendng unit
Date: 05/27/2020 09:54 am
hubcaps

Date: 06/05/2018 09:13 pm
Drivers side door panel Orange
Date: 05/22/2018 01:54 pm
need intake for oval port 2.3l
Date: 08/22/2018 09:23 am
1979 hatch needed
Date: 05/13/2018 08:52 pm
'80 Pinto Wagon
Date: 02/01/2018 05:20 pm
71,72 Pinto Door Panels

Date: 06/17/2018 08:27 pm
Wiring diagram Ignition switch 72 2.0 4 speed pinto wagon
Date: 12/31/2017 11:14 pm
Chilton's Repair & Tune-up Guide 1971-1979 Pinto and Bobcat

Date: 03/06/2017 01:24 am
WANTED Hood Prop Rod
Date: 01/17/2017 02:47 pm

Author Topic: 302 Transmission  (Read 1417 times)

0 Members and 1 Guest are viewing this topic.

Offline From_Jonah

  • Pinto Full Member
  • ***
  • Posts: 155
  • FeedBack: +0/-0
  • Gender: Male
  • Another Pinto Driver

  • Total Badges: 5
    Badges: (View All)
    Fifth year Anniversary Mobile User Topic Starter Signature Poll Voter
302 Transmission
« on: February 23, 2013, 11:07:32 PM »
I'm wanting to do a 302 swap. Hopefully I'll have the motor in the next week but I'm wondering what transmission I'll need. Will my stock 4 speed work with a different bell housing?
1977 wagon - baby blue full restoration project.

1980 wagon - (77 front clip) converted to cruising wagon. (Sold in 2015. Can’t find her again.)

Offline bob289

  • Pinto Driver
  • *
  • Posts: 3
  • FeedBack: +0/-0
  • Gender: Male
  • Another Pinto Driver

  • Total Badges: 3
    Badges: (View All)
    Fifth year Anniversary Signature Windows User
Re: 302 Transmission
« Reply #1 on: February 24, 2013, 06:18:50 AM »
it would never stay together behind a 302 i have a c4 in my crusin wagon but nephew has a mustang 4 speed in his wagon.
77crusinwagon with a 347 and automatic run at the strip also a 1978 pinto runabout with 2300 4 speed 8 inch ford posi 3.55 gears 5 lug all the way around 97 mustang bucket seats no rust Montana car. daily driver

Offline From_Jonah

  • Pinto Full Member
  • ***
  • Posts: 155
  • FeedBack: +0/-0
  • Gender: Male
  • Another Pinto Driver

  • Total Badges: 5
    Badges: (View All)
    Fifth year Anniversary Mobile User Topic Starter Signature Poll Voter
Re: 302 Transmission
« Reply #2 on: February 24, 2013, 07:49:12 AM »
Is a c4 a 4 speed transmission?
1977 wagon - baby blue full restoration project.

1980 wagon - (77 front clip) converted to cruising wagon. (Sold in 2015. Can’t find her again.)

Offline Norman Bagi

  • Founder PintoStampede.com
  • PCCA Management Board
  • Pinto Master
  • ******
  • Posts: 904
  • FeedBack: +51/-0
  • Gender: Male
  • Trail Boss "Pinto Stampede"
    • The Pinto Stampede

  • Total Badges: 10
    Badges: (View All)
    Tenth year Anniversary Topic Starter Signature Poll Voter Windows User Apple User Mobile User Webmaster Fifth year Anniversary Photographer
Re: 302 Transmission
« Reply #3 on: February 24, 2013, 10:41:49 AM »
C4 is a three speed automatic, no overdrive so highway speeds will be compromised unless you go with a small rear gear like a 3.25 and use big tires.  This will compromise how much power you put to the ground though. A T-5 will give you an overdrive, but will be tricky to do if you never did one.  Going back to the C4, you will need the mustang II bell housing, flywheel and torque converter to do a smooth fit.  otherwise you may have to tweek the tunnel with the BFH.