Forum > Your Project

Project Warhead

<< < (22/22)

warhead2:
Ok an update have only done some small stuff. I got the driver's spring readjusted was not in the bottom grove properly and got the upper n lower ball joint connected to the spindle. Then just clean n primed and undercoated the lower radiator support. Also sprayed flex seal on my hood hinge boots. Drivers boot was in good shape no rips. passengers boot is alot worse them a big split. I got both cleaned n coated l got 2 coats on both but will have to work with the passenger one to get the crack sealed. But this is my update incase anyone was wondering.

Sent from my SM-G965U using Tapatalk

Wittsend:
It will be interesting to see how the Flex Seal hold up. why do I see an image of Phil Swift spraying a Pinto with Flex Seal and driving it across a lake. LOL You might consider model aircraft fiberglass with Flex Seal applied as a possibility for the holes in the boots. Maybe it is something that can also be 3D printed? There are a number of "rubbery" plastics available.

warhead2:
Lol on the flex seal Pinto. I have some fiberglass drywall tape maybe that will work place on the inside then coat it.

Sent from my SM-G965U using Tapatalk

warhead2:
Worked on scraping some seam sealer inside the floor area no picture. Then decide on cleaning the underside on drivers rear passenger floor. I used a sanding sponge to clean up then mineral spirits to clean. I put down primer in preparation for undercoating with truck bed liner. Forgot a pic of the primer. Only worked this small area for now.

Sent from my SM-G965U using Tapatalk

warhead2:
Dropped the fuel tank tonight still had around
8 or 9 gallons left inside for 32yrs. Smells amazing lol. Cleaned the rust off one of the tank straps then primed all of it except where the bolt was just need to remove it just got tired and will do it later. Just need to clean up the underside now for undercoating

Sent from my SM-G965U using Tapatalk

Navigation

[0] Message Index

[*] Previous page

Go to full version