Current Classifieds

I have a 1977 Cobra body lots of parts here
Date: 04/12/2017 06:57 pm
Want seals for Pinto wagon "flip out" windows
Date: 08/08/2017 01:44 pm
FREE PARTS!!

Date: 01/10/2017 02:38 pm
Pinto Runabout wanted
Date: 06/05/2018 04:42 pm
2.3/C-4 torque converter needed
Date: 02/08/2018 02:26 pm
Pinto drive train

Date: 06/29/2018 08:32 am
FLOOR PANS
Date: 06/12/2020 07:24 pm
Built and Injected early 2000cc Engine

Date: 04/10/2017 07:30 pm
1979 PINTO PARTS--FREE
Date: 09/13/2022 02:05 pm
Wagon rear quarters
Date: 06/17/2020 03:32 pm
Need 77 or 78 Cruising Wagon Speedometer Tachometer Assembly
Date: 06/24/2020 06:12 am
need 1978 pinto guage cluster
Date: 03/07/2021 07:35 am

« previous next »
Pages: [1]   Go Down

Author Topic: 71 sedan rear end off center  (Read 1080 times)

0 Members and 1 Guest are viewing this topic.

Offline ZX10RDER

  • Pinto Driver
  • *
  • Posts: 6
  • FeedBack: +0/-0
  • Gender: Male
  • Another Pinto Driver

    • Total Badges: 3
    Badges: (View All)
    Mobile User Topic Starter Fifth year Anniversary
71 sedan rear end off center
« on: May 02, 2013, 11:44:39 PM »
Putting wide wheels on the back of my 71 sedan and found that the rear end is offset towards the driver side . Measured from backing plate to springs and axle is centered on the springs .it appears that spring mounts are offset on the body .with a bare wheel bolted to the axle and a straight edge across the wheel. measuring to the outer finder lip it is 1 inch offset to the driver side .has anyone had this problem if so any help will b greatly appreciated
Logged

Offline Srt

  • Original Pangra Master Builder
  • PCCA VIP
  • Pinto Master
  • ***
  • Posts: 1339
  • FeedBack: +100/-0
  • Gender: Male

    • Total Badges: 10
    Badges: (View All)
    Topic Starter Signature Tenth year Anniversary Poll Voter Linux User Mobile User Windows User 1000 Posts Fifth year Anniversary Photographer
Re: 71 sedan rear end off center
« Reply #1 on: May 04, 2013, 02:40:10 AM »
accident damage sometime in the past? you should get the same measurements (or very close to it) on both sides.
Logged
the only substitute for cubic inches is BOOST!!!
Pages: [1]   Go Up
« previous next »