Current Classifieds

Wanted Dash for Pinto up to 1975
Date: 01/19/2020 09:06 am
71-73 Hood
Date: 12/07/2018 06:22 pm
V8 rear end
Date: 04/12/2018 10:57 am
Drivers side door panel Orange
Date: 05/22/2018 01:54 pm
13x6 minilite style wheels MAKE OFFER——NEED GONE

Date: 08/01/2018 01:17 pm
1978 bobcat 4speed shifter
Date: 11/02/2023 09:51 pm
Free ford C3 transmission in 95695..
Date: 06/07/2021 08:14 pm
1978 RUNABOUT

Date: 04/01/2017 03:18 pm
2.3 engine mounts,glove box parts,emblems,hatch,doors,hinges etc
Date: 08/26/2018 06:35 pm
Floor pans for my 1975 Pinto Sedan
Date: 12/09/2016 08:34 am
1975 Pinto bumpers
Date: 10/24/2019 01:45 pm
74 hood
Date: 07/03/2017 03:46 pm

« previous next »
Pages: [1]   Go Down

Author Topic: 71 sedan rear end off center  (Read 1071 times)

0 Members and 1 Guest are viewing this topic.

Offline ZX10RDER

  • Pinto Driver
  • *
  • Posts: 6
  • FeedBack: +0/-0
  • Gender: Male
  • Another Pinto Driver

    • Total Badges: 3
    Badges: (View All)
    Mobile User Topic Starter Fifth year Anniversary
71 sedan rear end off center
« on: May 02, 2013, 11:44:39 PM »
Putting wide wheels on the back of my 71 sedan and found that the rear end is offset towards the driver side . Measured from backing plate to springs and axle is centered on the springs .it appears that spring mounts are offset on the body .with a bare wheel bolted to the axle and a straight edge across the wheel. measuring to the outer finder lip it is 1 inch offset to the driver side .has anyone had this problem if so any help will b greatly appreciated
Logged

Offline Srt

  • Original Pangra Master Builder
  • PCCA VIP
  • Pinto Master
  • ***
  • Posts: 1339
  • FeedBack: +100/-0
  • Gender: Male

    • Total Badges: 10
    Badges: (View All)
    Topic Starter Signature Tenth year Anniversary Poll Voter Linux User Mobile User Windows User 1000 Posts Fifth year Anniversary Photographer
Re: 71 sedan rear end off center
« Reply #1 on: May 04, 2013, 02:40:10 AM »
accident damage sometime in the past? you should get the same measurements (or very close to it) on both sides.
Logged
the only substitute for cubic inches is BOOST!!!
Pages: [1]   Go Up
« previous next »