Current Classifieds

WTB: Ford Type 9 5spd Transmission
Date: 03/18/2020 01:30 am
LOTS OF 1971-1973 PARTS FOR SALE
Date: 02/03/2018 11:28 am
Wiring diagram Ignition switch 72 2.0 4 speed pinto wagon
Date: 12/31/2017 11:14 pm
Wanted - Offenhauser intake for 2.8l (6097DP)
Date: 01/28/2019 05:15 pm
Mallory Unilight dist 2.0
Date: 10/25/2019 03:44 pm
Needed:73 Pinto center console/change tray
Date: 12/09/2018 11:35 pm
Need 77 or 78 Cruising Wagon Speedometer Tachometer Assembly
Date: 06/24/2020 06:12 am
Pinto Fiber Glass Body Parts
Date: 01/06/2019 06:53 pm
74 Wagon body parts and a couple of 79 bits

Date: 11/14/2019 04:02 am
Early V8 swap headers, damaged, fixable?
Date: 10/25/2019 03:30 pm
1976 pinto for sale

Date: 01/12/2017 02:08 pm
Oddsnends
Date: 12/20/2016 10:52 am

« previous next »
Pages: [1]   Go Down

Author Topic: Engine Light on - 1971 2.0 / oil pressure relief valve Location??  (Read 1145 times)

0 Members and 1 Guest are viewing this topic.

Offline Crazy Lacy

  • Pinto Member
  • **
  • Posts: 64
  • FeedBack: +4/-0
  • Gender: Male
  • Captain America Pinto

    • Total Badges: 2
    Badges: (View All)
    Topic Starter Signature
Engine Light on - 1971 2.0 / oil pressure relief valve Location??
« on: September 05, 2017, 02:08:12 PM »
My repair books says oil pressure relief valve could be sticking, but I don't see anything about what and where it's located in the book ?? :-\

Also, is there a way to test the sending unit?, I was thinking on pulling the Valve cover and crank it over to see if the oil is flowing there.

Logged
Join my - Pinto Ford USA - on Face Book.

William "Crazy Lacy" Furmage
Original Vans BMX Freestyle Pioneer 1982

Offline Crazy Lacy

  • Pinto Member
  • **
  • Posts: 64
  • FeedBack: +4/-0
  • Gender: Male
  • Captain America Pinto

    • Total Badges: 2
    Badges: (View All)
    Topic Starter Signature
Re: Engine Light on - 1971 2.0 / oil pressure relief valve Location??
« Reply #1 on: September 14, 2017, 10:39:48 PM »
I notice that once i replaced the Voltage Regulator the eng light went out, That one hole in the back of the dash gauge set up is usually for the oil dummy light. I'll pull it out and see what the heck is going on there. ???
Logged
Join my - Pinto Ford USA - on Face Book.

William "Crazy Lacy" Furmage
Original Vans BMX Freestyle Pioneer 1982
Pages: [1]   Go Up
« previous next »