Current Classifieds

1970-1973 British 4 Speed Manual; Parts or Whole
Date: 03/17/2019 03:57 am
WTB: Factory air cleaner and fan shroud 1971 2.0
Date: 02/05/2020 11:06 am
74 4 spd and rear axle
Date: 09/26/2018 03:51 pm
Need lower control arms for 1973 pinto
Date: 02/27/2017 10:10 pm
Wheels and Parts

Date: 07/06/2018 04:50 pm
Pinto porthole exterior trim wanted
Date: 03/30/2021 12:29 pm
71-73 sway bar
Date: 06/12/2021 10:12 am
WTB. Seat cover or material LFront
Date: 07/01/2019 03:17 pm
1980 Pinto Pony for sale

Date: 08/21/2021 03:54 pm
2.3 carb intake

Date: 07/15/2020 09:25 pm
77 Caliper Bolt
Date: 08/21/2018 04:02 pm
1977 Pinto Cruising Wagon FOR SALE

Date: 08/20/2017 01:34 pm

« previous next »
Pages: [1]   Go Down

Author Topic: Adding Gear Oil to Rear Differential  (Read 3413 times)

0 Members and 1 Guest are viewing this topic.

Offline John Turner

  • Pinto Member
  • **
  • Posts: 56
  • FeedBack: +0/-0
  • Another Pinto Driver

    • Total Badges: 3
    Badges: (View All)
    Topic Starter Fifth year Anniversary Apple User
Adding Gear Oil to Rear Differential
« on: February 15, 2012, 03:03:48 PM »
72 Pinto Station Wagon - I removed rear differential cover, drained gear oil, put on new gasket, replaced cover.  I cannot find any way to replace the gear oil.  There is a "breather" hose on the top center of the differential with a small rubber 10" long hose that goes up into a crossmember.  I tried to add oil thru this hose, no good.  Then removed the fitting for this "breather" on the top of the differential housing and my next effore will be to attempt to dribble a quart or so of gear oil thru this tiny fitting hole.  I have to believe that this is wrong.  I cannot find any other fittings on the rear end/differential housing anywhere to add oil.  Just this little fitting with a hose that goes off the top center of the housing.  If they are there I must have missed them.  I may go crazy here.  Help.  Thanks jt
Logged

Offline dave1987

  • Pinto Sr. Master
  • ******
  • Posts: 3431
  • FeedBack: +25/-0
  • Gender: Male

    • Total Badges: 11
    Badges: (View All)
    Topic Starter Signature Tenth year Anniversary Poll Voter Mobile User Apple User Linux User Windows User 1000 Posts Fifth year Anniversary Photographer
Re: Adding Gear Oil to Rear Differential
« Reply #1 on: February 15, 2012, 04:39:50 PM »
When looking at the differential from the drive shaft side, there is a fill "bolt" to the right side, right above the half way casting line, kind of in a "corner".

To remove it you need a 3/8" extension (a three inch works great) on a 3/8" ratchet handle. To put it back on just put the fill cap/bolt on the end of the extension and screw it back in.


When filling, put a pan under the fill hole and pump fluid in until it starts to pour/drip out of the hole/differential.
Logged
1978 Ford Pinto Sedan - Family owned since new

Remembering Jeff Fitcher with every drive in my 78 Sedan.

I am a Pinto Surgeon. Fixing problems and giving Pintos a chance to live again is more than a hobby, it's a passion!

Offline scouttster

  • Pinto Driver
  • *
  • Posts: 4
  • FeedBack: +0/-0
  • Another Pinto Driver

    • Total Badges: 2
    Badges: (View All)
    Fifth year Anniversary Topic Starter
Re: Adding Gear Oil to Rear Differential
« Reply #2 on: February 16, 2012, 09:06:27 AM »
Its there..  I just did this myself.  Looking at the butt-end of the car.  And crawling under the car from the rear you will find it on the LEFT hand side.  It sometimes get filled with dirt and can be difficult to spot..  A good flashlight and an inspection mirror helped me locate it..   
Logged

Offline John Turner

  • Pinto Member
  • **
  • Posts: 56
  • FeedBack: +0/-0
  • Another Pinto Driver

    • Total Badges: 3
    Badges: (View All)
    Topic Starter Fifth year Anniversary Apple User
Re: Adding Gear Oil to Rear Differential
« Reply #3 on: February 16, 2012, 01:15:04 PM »
I found it thanks to the advice.  It was totally covered with crud etc.  What a hassle.  Thanks very much.  jt
Logged
Pages: [1]   Go Up
« previous next »