Current Classifieds

Pinto Watch

Date: 06/22/2019 07:12 pm
72 PINTO WAGON

Date: 09/23/2018 06:16 pm
Need Mustang II Manual Transmission Mount
Date: 04/21/2017 02:03 pm
Looking for a 1977 Ford Pinto Runabout Hatchback
Date: 10/15/2017 10:03 am
Wanted early pinto
Date: 10/03/2019 02:42 pm
Parts for 74 Squire Wagon
Date: 09/16/2019 07:35 pm
Wanted 2.3 engine mount brackets and mounts
Date: 02/14/2018 01:34 am
Looking for a Single Stage Nitrous Kit/ 2-bbl Holley Spray Bar Plate
Date: 01/06/2017 11:42 pm
Want side to side luggage rack rails for '75 Pinto wagon
Date: 08/30/2018 12:59 am
WTB 1974 or 1975 Pinto Grille and Turn Signals
Date: 04/08/2018 05:47 pm
ford pinto door panels
Date: 03/20/2022 07:51 pm
hood for a 79-80
Date: 11/30/2018 10:55 pm

Author Topic: 71 sedan rear end off center  (Read 951 times)

0 Members and 1 Guest are viewing this topic.

Offline ZX10RDER

  • Pinto Driver
  • *
  • Posts: 6
  • FeedBack: +0/-0
  • Gender: Male
  • Another Pinto Driver

  • Total Badges: 3
    Badges: (View All)
    Mobile User Topic Starter Fifth year Anniversary
71 sedan rear end off center
« on: May 02, 2013, 11:44:39 PM »
Putting wide wheels on the back of my 71 sedan and found that the rear end is offset towards the driver side . Measured from backing plate to springs and axle is centered on the springs .it appears that spring mounts are offset on the body .with a bare wheel bolted to the axle and a straight edge across the wheel. measuring to the outer finder lip it is 1 inch offset to the driver side .has anyone had this problem if so any help will b greatly appreciated

Offline Srt

  • Original Pangra Master Builder
  • PCCA VIP
  • Pinto Master
  • ***
  • Posts: 1339
  • FeedBack: +100/-0
  • Gender: Male
  • Pinto Stampede ROCKS

  • Total Badges: 10
    Badges: (View All)
    Topic Starter Signature Tenth year Anniversary Poll Voter Linux User Mobile User Windows User 1000 Posts Fifth year Anniversary Photographer
Re: 71 sedan rear end off center
« Reply #1 on: May 04, 2013, 02:40:10 AM »
accident damage sometime in the past? you should get the same measurements (or very close to it) on both sides.
the only substitute for cubic inches is BOOST!!!