Nothing is easy.....
You can see the plate that the original builder brazed onto the bottom of the tank for the fuel line.
I buffed a small area to weld on a new 8AN bung......and water (had tank full) started pouring out of the brazed edge.
Empty & dry tank.
It was mounted from inside the trunk, on the sub frame......wit
h a really good silicone.
Not sure how I'm going to get it out. I can only get at the front edge with tools. Sides & back are too close to the tubs.
Has to come out though.....
(that fuel pump and lines are gone - all new stainless lines, fuel pump, pre-filter has been installed.