Shiny is Good!
Home
Forum
Help
TinyPortal
Search
Classifieds
Downloads
Gallery
Search
Stats
Store
Links
Advertise
Login
Register
PINTO CAR CLUB of AMERICA
»
Forum
»
Shiny is Good!
»
Your Pintos/Bobcats & Racers
»
Topic:
Manual transmission outputshaft size??
12 Guests, 2 Users
davidpinto
,
krazi
Association Sites
PintoStampede.com
Pinto Page
MustangII.org
AMCGremlin.com
AMCPacer.com
Bullet Stop Guns
Site Features
Show Unread Posts
Show New Replies
PCCA Official Links
PCCA Member Map
PCCA Member Galleries
Charter Members, VIPs, Club Management
PCCA Meets-Car Shows
Pinto Production Statistics
Help Center
PCCA
CLASSIFIEDS
YOUR
SOURCE
« previous
next »
Print
Pages: [
1
]
Go Down
Author
Topic: Manual transmission outputshaft size?? (Read 1166 times)
0 Members and 1 Guest are viewing this topic.
sponge003
Pinto Member
Posts: 32
FeedBack: +0/-0
Another Pinto Driver
Total Badges: 2
Badges:
(View All)
Manual transmission outputshaft size??
«
on:
June 23, 2014, 06:46:51 PM »
Hi,
Building a road racer for lemons racing and have put a 8.8 rear end in it out of a Turbo Tbird. I am going to run the 4 speed manual and am having a hell of a time finding out what output spline size is so I can investigate the driveshaft options.
I know some people have used an aluminum rear driveshaft from a 97 4wd Aerostar van but I don't know what the splines are to make sure it can work.
I can probably use the stock driveshaft and get a flange yoke for the 8.8 and a crossover U-joint and make it work.
Appreciate the help
Paul
Logged
82expghost
Pinto Full Member
Posts: 154
FeedBack: +84/-0
Die tires die!
Total Badges: 5
Badges:
(View All)
Re: Manual transmission outputshaft size??
«
Reply #1 on:
July 03, 2014, 01:20:31 AM »
i cut down a foxbody manual tranny 8.8 driveshaft, and it fit in my t9, and the t9 is the same as pinto 4 speed, if any help
Logged
98 taurtus, now in heaven
82 exp, the race car, cancer took it away
77 pinto, weekend warrior
92 grand marquis, daily
amc49
PCCA VIP
Pinto Master
Posts: 1256
FeedBack: +242/-1
Another Pinto Driver
Total Badges: 4
Badges:
(View All)
Re: Manual transmission outputshaft size??
«
Reply #2 on:
July 05, 2014, 03:25:48 PM »
The C3 output is the same as well, at least on a '80 model with MTX.
Logged
Print
Pages: [
1
]
Go Up
« previous
next »
PINTO CAR CLUB of AMERICA
»
Forum
»
Shiny is Good!
»
Your Pintos/Bobcats & Racers
»
Topic:
Manual transmission outputshaft size??