Current Classifieds

Clutch Cable Needed
Date: 04/03/2017 11:03 pm
Looking for Passenger side Inner Fender Apron
Date: 10/28/2018 08:45 am
Pinto Parts for sale
Date: 06/19/2017 02:01 pm
1977 Pinto for parts

Date: 10/10/2018 06:25 pm
Front sway bar

Date: 07/23/2018 08:19 pm
2.0 Cyl Head1973
Date: 11/29/2018 12:51 pm
FREE PARTS!!

Date: 01/10/2017 02:38 pm
hubcaps

Date: 10/31/2018 12:04 pm
Right side strut mount for 3rd door 1979 runabout
Date: 10/04/2019 08:43 pm
74 Pinto Hub Caps & Trim Rings

Date: 02/18/2017 04:47 pm
72 pinto drag car

Date: 06/22/2017 07:19 am
1977 Pinto for parts

Date: 10/10/2018 06:25 pm

Author Topic: Does your outside door handle button stick and not release ?? Easy fix...  (Read 4045 times)

0 Members and 1 Guest are viewing this topic.

Offline Starliner

  • Pinto Sr. Member
  • ****
  • Posts: 409
  • FeedBack: +16/-0
  • Gender: Male

  • Total Badges: 5
    Badges: (View All)
    Topic Starter Signature Tenth year Anniversary Poll Voter Fifth year Anniversary
My outside door handle button started sticking and would not release.   I had to tap on the door handle to get it to release.
 
It was an easy fix. 
Go buy a spray can of white lithium grease that comes with a spray tube.  (I like CRC)
 
Open the door and leave it open.
Unsnap the side of the inside door panel on the side towards the door handle.  Also unclip one on the top and on the bottom.     Be careful doing this so you dont' rip the cardboard of the door panel from the clips.    This should allow the door panel to be pulled back a little bit.
 
Roll up the window.
Pull back the door panel a little and place a flashlight inside the door pointing up so you will be able to view the door handle assembly.
 
Shake the can of the white lithium grease and install the spray tube.
Do a test spray in your trash can. 

Now lay on the ground looking up into your door while pulling the door panel back a little.
You will see the door lock/latching system. 
Aim the spray nozzle to spray that lever that is located above the push button.    Put the white lithium grease on heavy.
Push the button to see if it's fixed.  I am sure it is. 
Push the button in multiple times to work some grease into the pivots.  Spray it again. 
 
Now remove the flashlight and re-attach the door panel.  Make sure the door panel clips are partially started into the holes of the door before you pound on them.
 
Done!
 
 
 
 
1973 Pinto 1600 - Sold!  
1979 Pinto 2300 - Sold!
1984 Audi 5000 Avant - 60,000 original miles
1987 Audi 5000 S Quattro - The snowmobile
1973 Volvo 1800 ES wagon -  my project car
1976 Mustang II - Wifey's new toy

Offline blupinto

  • Pinto PooBAH
  • ******
  • Posts: 3872
  • FeedBack: +63/-0
  • Gender: Female
  • My Original Blu '72

  • Total Badges: 9
    Badges: (View All)
    Topic Starter Signature Mobile User Tenth year Anniversary Poll Voter Windows User 1000 Posts Fifth year Anniversary Photographer
Re: Does your outside door handle button stick and not release ?? Easy fix...
« Reply #1 on: November 08, 2011, 07:02:38 PM »
AAACK!!! NOW you tell me!!! lol ::)

I did indeed have a sticky door handle button... except to release the darn button I had to give the door a good POUND with my fist. (No there are no door dings for all my abuse! lol).  Except for not using lithium grease (I used a normal WD-40 like lubricant) I did what you said. No more sticky door!  ;D
One can never have too many Pintos!

Offline Starliner

  • Pinto Sr. Member
  • ****
  • Posts: 409
  • FeedBack: +16/-0
  • Gender: Male

  • Total Badges: 5
    Badges: (View All)
    Topic Starter Signature Tenth year Anniversary Poll Voter Fifth year Anniversary
Re: Does your outside door handle button stick and not release ?? Easy fix...
« Reply #2 on: November 11, 2011, 10:09:33 AM »
I used white lithium because I have found WD40 does not last very long for me.
1973 Pinto 1600 - Sold!  
1979 Pinto 2300 - Sold!
1984 Audi 5000 Avant - 60,000 original miles
1987 Audi 5000 S Quattro - The snowmobile
1973 Volvo 1800 ES wagon -  my project car
1976 Mustang II - Wifey's new toy

Offline dieseldave4443

  • Pinto Member
  • **
  • Posts: 21
  • FeedBack: +0/-0
  • Gender: Male
  • Another Pinto Driver

  • Total Badges: 2
    Badges: (View All)
    Topic Starter Fifth year Anniversary
Re: Does your outside door handle button stick and not release ?? Easy fix...
« Reply #3 on: November 16, 2011, 09:28:43 AM »
I will definetly try it! There's no need to use that funky little panel removing tool? Bit apprehensive to since parts seem scarce?

Offline dave1987

  • Pinto Sr. Master
  • ******
  • Posts: 3431
  • FeedBack: +25/-0
  • Gender: Male

  • Total Badges: 11
    Badges: (View All)
    Topic Starter Signature Tenth year Anniversary Poll Voter Mobile User Apple User Linux User Windows User 1000 Posts Fifth year Anniversary Photographer
Re: Does your outside door handle button stick and not release ?? Easy fix...
« Reply #4 on: November 16, 2011, 11:25:35 AM »
I use a door panel removal tool like this one (Matco brand but still the same design):

http://www.sears.com/shc/s/p_10153_12605_SPM5785114201P?i_cntr=1321464270500

It's wide enough to grab enough panel so as not to tear anything, and ridged enough to pop out the clip the first try.
1978 Ford Pinto Sedan - Family owned since new

Remembering Jeff Fitcher with every drive in my 78 Sedan.

I am a Pinto Surgeon. Fixing problems and giving Pintos a chance to live again is more than a hobby, it's a passion!