PINTO CAR CLUB of AMERICA
Welcome to FordPinto.com, The home of the PCCA => Parts Resources, Here is where you can find this or that. => Topic started by: 442 on January 14, 2017, 02:52:55 AM
-
Does anyone know where to get the lift struts for the back hatch for a 72 pinto? I see AutoZone lists a set for 73' and up, but not for 72'. Is there any difference in the back hatch for those years?
Thanks!
-
Should be the same. I am running foxbody mustang ones on my 73. They were off an 89 GT I parted. They seem to work ok.
-
Thanks, I'll try the 73' struts.
-
For anyone looking for these lift supports, I did buy the part number listed by AutoZone for 73' Pinto ( SG304004), and they work fine for my 72' Runabout. The other source that crosses to this part number is the StrongArm 4405 commonly found on eBay and other places.
Richard
-
I''m wondering with the changeover from the original Pinto platform to the Mustang II platform causes a lot of common parts to all years to be dropped for 71-73. Sort of an "Oh their different" and like an urban legend it gets applied to every Pinto part 71-73.
-
I do remember my 72 had arms that hooked to the liftgate , in had springs on the inside with a shaft sticking out to put the arms on , someone here may have a photo of it to show you what they looked like ,
-
Looking through some old ebay photo's, it appears 1972 might be a cross over year going from interior coil spring with lift arms to the pressured strut design. I found photo's showing both styles for 1972, see below. This is probably why AutoZone did not list a strut for the 1972.
-
My 72 (Ugly Yellow) has the same as the bottom picture.