PINTO CAR CLUB of AMERICA
Welcome to FordPinto.com, The home of the PCCA => Parts Resources, Here is where you can find this or that. => Topic started by: Reeves1 on June 19, 2013, 07:54:08 AM
-
Been trying to find one. Got one ?
-
Have you tried a 5.0 fork in it? That fork fit my D9 bell perfectly
-
You have one you can take measurements from ?
I'll do same with the one I have (need 2 total) tomorrow.
-
http://www.npdlink.com/store/catalog/Mustang_Clutch_Linkage-6190-1.html
Might work ? I sent them an e-mail.
Off to the shop now....
-
Summit sells one for 20 bucks. That's where I got mine. Mine is buried in my storage but I did check the fit in my D9 bell a year ago & it was perfect.
http://www.fordpinto.com/pinto-faq/comparison-between-d5-d9-direct-pull-bellhousings/ (http://www.fordpinto.com/pinto-faq/comparison-between-d5-d9-direct-pull-bellhousings/)
-
http://www.summitracing.com/parts/atp-za125/overview/ (http://www.summitracing.com/parts/atp-za125/overview/)
-
Cheap !
Ordered it !
;D
-
Cool 8)
-
http://www.summitracing.com/parts/atp-za125/overview/ (http://www.summitracing.com/parts/atp-za125/overview/)
Same, except made in China.
Never mind the bubbles in the weld on the blue one (will be re-done). Also, that welder will be given back to the neighbor/owner. I bought a new one that works right.
(http://img.photobucket.com/albums/v140/DerrickJB/Yellow%2072/IMG_0241_zpsc608037a.jpg) (http://smg.photobucket.com/user/DerrickJB/media/Yellow%2072/IMG_0241_zpsc608037a.jpg.html)
-
I knew it would work. Only difference is the hole is larger than the Pinto cable ball but it's an easy fix.
-
My fix for the blue one was to cut that small piece out of a Pinto fork & weld it in.
You have other ways to fix ?
I got another Pinto fork to cut up....
-
Most guys just cut a slot in a washer that has a small hole after cupping it with a ball peen hammer & weld it in