Current Classifieds

Clutch Pedals for 75to 80 Pinto
Date: 09/21/2018 11:35 am
FLOOR PANS
Date: 06/12/2020 07:24 pm
PINTO TRUNK LATCH & CATCH

Date: 03/23/2018 09:39 pm
74 Pinto Rear Side Lights

Date: 02/18/2017 05:47 pm
looking for 1978 pinto head rebuild kit
Date: 05/24/2020 08:19 am
Bell housing
Date: 08/23/2017 05:41 am
1980 pinto/bobcat floors
Date: 07/24/2018 08:11 pm
Pinto porthole exterior trim wanted
Date: 03/30/2021 12:29 pm
1978 pinto brake booster needed.
Date: 04/07/2021 06:12 pm
71-73 2.0 4 speed transmission wanted
Date: 09/06/2020 01:57 am
1975 rear end, 8 inch, drum brakes, and axles, 3.4 gear.

Date: 11/08/2019 10:01 am
79 pinto small parts
Date: 04/24/2019 03:16 pm

Author Topic: Ford 2 bbl Carb on Offenhauser Manifold  (Read 1661 times)

0 Members and 1 Guest are viewing this topic.

Offline lesterwa58

  • Pinto Member
  • **
  • Posts: 28
  • FeedBack: +0/-0

  • Total Badges: 4
    Badges: (View All)
    Tenth year Anniversary Topic Starter Windows User Fifth year Anniversary
Ford 2 bbl Carb on Offenhauser Manifold
« on: April 09, 2013, 08:06:42 PM »
I have an Offenhauser 4 barrel manifold to go on my 2300 engine, but I have a conversion to install a Motorcraft (Ford) 2 barrel carburator on this manifold.  Am I going to have a problem with hood clearence using the stock hood? If so how can I remedy this problem without cutting into the hood?  Also what do I need for linkage, and where would I buy such linkage?  Wes Jones, Cle Elum, WA  e-mail: lesterwa58@yahoo.com