Forum > It's all about the Turbo...

A 1972 turbo swap adventure

<< < (2/61) > >>

!!!! good project.

74 PintoWagon:
It's looking good, good luck on the project..

Race engineering sells a pan I'm looking at, very similar to that.

I went back and looked and I guess it came from Jonson Machine. Whether they built it or just sold it, I don't know. Could be a C-Line.


It's really tempting to cheap out and use the crush-bent stock 2.25" downpipe, but I'm probably going to use that mandrel u-bend in the back to make a 2.5" one.

It's not much to look at, but this is a 6061 dipstick plug. Two o-rings to seal and an interference fit at the top.


[0] Message Index

[#] Next page

[*] Previous page

Go to full version