Forum > It's all about the Turbo...
A 1972 turbo swap adventure
Srt:
!!!! good project.
74 PintoWagon:
It's looking good, good luck on the project..
don33:
Race engineering sells a pan I'm looking at, very similar to that.
65ShelbyClone:
I went back and looked and I guess it came from Jonson Machine. Whether they built it or just sold it, I don't know. Could be a C-Line.
65ShelbyClone:
More.
It's really tempting to cheap out and use the crush-bent stock 2.25" downpipe, but I'm probably going to use that mandrel u-bend in the back to make a 2.5" one.
It's not much to look at, but this is a 6061 dipstick plug. Two o-rings to seal and an interference fit at the top.
Navigation
[0] Message Index
[#] Next page
[*] Previous page