Current Classifieds

1973 FORD PINTO HOOD "F O R D" LETTERS
Date: 02/11/2020 12:09 am
'72 Runabout Drivers Side Door Hinge Set
Date: 12/15/2018 02:21 am
Wanted Pinto Fiberglass Body Parts
Date: 05/19/2018 04:56 pm
78 wagon instrument y
Date: 04/30/2018 07:41 pm
71-73 sway bar
Date: 06/12/2021 10:12 am
75 wagon need parts
Date: 05/28/2020 05:19 pm
pintos for sale
Date: 12/11/2018 04:29 pm
Want seals for Pinto wagon "flip out" windows
Date: 08/08/2017 01:44 pm
nos core support

Date: 01/03/2020 09:39 pm
1980 Pinto Parts

Date: 08/05/2020 04:20 pm
Early 2.0 engines
Date: 05/09/2018 12:45 pm
1973 Ford Pinto, Shift linkage for a/t and cross member
Date: 02/25/2017 08:45 pm

« previous next »
Pages: [1]   Go Down

Author Topic: motor mounts for 2.3 turbo.  (Read 2045 times)

0 Members and 1 Guest are viewing this topic.

Offline L.D

  • Pinto Member
  • **
  • Posts: 46
  • FeedBack: +16/-0
  • Another Pinto Driver

    • Total Badges: 4
    Badges: (View All)
    Topic Starter Windows User Linux User Mobile User
motor mounts for 2.3 turbo.
« on: September 13, 2013, 07:17:22 PM »
starting to mock up my motor mounts in my 71 for 2.3 merkur swap and a t-9 looking at some recent photos it looks like one of the holes just about lines up with the exiting nuts. Do you have to cut the back side of the mount that is going to be welded to the frame because of the flare on the bottom of the frame going towards the cross member or gring that area flat?
Logged

Online Wittsend

  • Pinto Master
  • *****
  • Posts: 2498
  • FeedBack: +241/-0

    • Total Badges: 8
    Badges: (View All)
    Tenth year Anniversary Mobile User Topic Starter Poll Voter 1000 Posts Linux User Windows User Fifth year Anniversary
Re: motor mounts for 2.3 turbo.
« Reply #1 on: September 13, 2013, 08:44:38 PM »
Here are a couple of pictures of my 2.3 Turbo in a '73 wagon.  You might have it slightly easier because the '73 has a odd one year only rack that has a bulbous knob on it.

 As it regards the passenger side (showing in the picture), and the lower front threaded bolt hole in the frame rail; my lower front mount hole (center) is 3/4" down and 1/4" to the rear of that hole. You can faintly see this in the first picture. If you can enlarge it, it may help.  I don't remember grinding other than removing the old mounts. Likely every car is different so my measurement should just be considered ballpark.

 I had my engine in/out 7 times before I was willing to commit. Every car is likely different  and everything it SO tight, probably 3/16" clearance at the rack, oil pan, starter bearing and hood (also 1/4" at the pulley bolt to radiator).

All the best.  Frankly pulling the trigger on the MIG was like saying "I do" at my wedding.

Tom
Logged
Pages: [1]   Go Up
« previous next »