Forum > It's all about the Turbo...
73 swap update
Wittsend:
I'm using the factory '74-up 2.3 mounts in my '73. It requires cutting out the original mount and welding the new mounts in. I know I have answered this question numerous times with pictures (I think). Search my posts (Wittsend) and you should find something. I've included a picture of the passenger side engine bay. Note that the battery tray and (rusted) panel have been removed/replaced.
Frankly it is VERY tight if you want the hood to close. I had my engine in/out 7 times before I committed to welding them in. There is one bolt hole that looks close, but in my case not close enough.
Tom
Rebolting73:
Hi, here are some shots. First, Wittsend has some great swap posts, I read them and studied them. So, to follow along, engine out, cut stock mounts off, get Mustang II mounts, hang engine and tranny is and hook up the tranny mount and center it. I used a Harbor Freight front wheel drive cross bar to hang the engine while adjusting (cuz I had one handy). Left, right, up down...beat the pan a little,shave the rack and pinion mount shoulder. I C-clamped the mounts to the frame and then tacked it in and them buzzed it in and called it a day. If these pics come up short I have a bunch more..Hope it helps.
65ShelbyClone:
--- Quote from: JCR on October 17, 2013, 08:18:53 PM ---I'm in the process of putting in a 87 Turbo 2.3 in my 73 Pinto.
Need some advise fir the engine mounts, both steel which bolt to the block, engine mounts and frame mounts.
Do you have pictures of these and where I can get them these items?
--- End quote ---
I have found myself in the same situation in the last few days and your question seems to be the $64,000 one.
Where does one go to get these frame mounts for the 2.3 engine? Are there reproductions available or do I have to scrounge them from a junkyard car? (easier said than done)
Pinto5.0:
--- Quote from: 65ShelbyClone on May 12, 2014, 02:40:32 AM ---Where does one go to get these frame mounts for the 2.3 engine? Are there reproductions available or do I have to scrounge them from a junkyard car? (easier said than done)
--- End quote ---
Used is about it. I've heard that V6 frame mounts are the same as 4 bangers. If you can't find any in the boneyard or through here try Facebook (Ford Pinto Fan Club) or check Craigslist for any Pintos being parted out. You would be amazed what you can find if you post a "WANTED" ad on Craigs for Pinto parts.
Rebolting73:
Hi, here are some shots of my trip to the bone yard for the mounts from a Mustang II. Hope it helps.
Navigation
[0] Message Index
[#] Next page
[*] Previous page