Pinto Car Club of America
Shiny is Good! => Your Project => Topic started by: vbpinto on May 23, 2008, 06:20:09 PM
I have everytihng mocked up dangling in the engine bay so i can test and hear it run, before i go installing the harness and lengthening and shortening wires as needed. I have fuel pump operational, injectors are firing, but no coil power or spark. Is there wires from the pinto harness i need to splice in??? i have hooked everything up from the merkur harness just as it came out. All of the power and grounds. There is 2 connectors that i couldnt hook up, one under the dash that was brown and square. also one that hooked up on driver side fenderwell in the engine compartment. Any ideas???
Try this guy wwwrapidogroup.com hope this helps.
I have no experience with the Merkur harness but the following links may help you start to figure it out. If you are not using the Merkur computer, you may also need to rearrange some of the wires at the computer connector.
http://www.gt350mustang.com/eecspecsturbo.htm
http://www.blindchickenracing.com/how_to/t-bird_install/t-birdwiring.jpg