Text only | Text with Images

Pinto Car Club of America

Welcome to FordPinto.com, The home of the PCCA => Pinto FAQ => Topic started by: tony v on May 29, 2007, 11:46:29 AM

Title: Torque Specs. (WELL, i found it !!)
Post by: tony v on May 29, 2007, 11:46:29 AM
 ;D this was nutz! couldnt find torque specs for the mains on a 2.3. Turbowagonman, i did come through!! it is 85 lbs./// go 30lbs, side to side, then 60lbs,side to side , then 85lbs, side to side, then recheck at 85.   thank you terry in washington!!!
Title: Re: WELL, i found it !!
Post by: turbowagonman on May 29, 2007, 07:05:31 PM
Glad to hear that Tony, also glad to hear you can get your DD on the road again!I'll write that down in my Manual for future referance.  ;D
Did you gat your Motor yet?

Shawn
Title: Re: WELL, i found it !!
Post by: tony v on May 29, 2007, 07:13:40 PM
hey turbo wagon, i called and it is on its way!! :amazed: the cam # on the invoice is ...205-bpt delta roller cam and the part # for the roller rockers is ...r-922 the long block should be here tomorrow! yippie ki-o-ki-a. the bearrings in ponelopy, my dd are lookin pretty bad. i think im gonna rebuild her. i got it ripped out and tore down so might as well.  write those specs down. when i get the build sheet on the race motor ,.... i will post them.   rubber side down!!
Title: Re: WELL, i found it !!
Post by: oldkayaker on May 29, 2007, 08:33:22 PM
This link appears to have an excerpt from a Ford manual.  Not sure what year it is for but it may help.  Original Ford manuals come up on ebay occasionally at reasonable prices.
http://www.rothfam.com/svo/reference/23torque.pdf
Title: Re: WELL, i found it !!
Post by: tony v on June 25, 2007, 08:25:11 AM
thanx oldkayaker, im gonna check it and hope i find a good manual.
Text only | Text with Images