Pinto Car Club of America

Hey guys been a Long time since i been on the Pinto site I had to reregister.

Any information about getting the early front ends to a 5 lug other than WillWood.
Has anyone meashured the differences and thought out a mod to get the later modle to fit?
And what would be a good source for NEW rotors? Maybe I could buy them blank and have them Drilled.

Frank Canon

you can get a kit to install granada frony brakes on the pinto factory spindles.  try this:   http://dwayne9.addr.com/mustang_ii.html (http://dwayne9.addr.com/mustang_ii.html)

down near the bottom of the page.

That website is great if you own a 74 and up model pinto but the 73 and down fornt susention is different.
I wished I could hang the front over to later model control arms and spindles. it would make things simple.

Frank

ive been informed that Aerospace has a kit available at Jegs

 Please stop by the FAQ section from time to time. I am doing a Granada/Wilwood 5 lug conversion to my 73.

New pictures as of 9/8/04

Quote from: 78pinto on February 22, 2004, 11:26:18 AM
you can get a kit to install granada frony brakes on the pinto factory spindles.  try this:   http://dwayne9.addr.com/mustang_ii.html (http://dwayne9.addr.com/mustang_ii.html)

down near the bottom of the page.
[/quot e]        usbrake and areospace sells a kit 4 around $550

 Not sure what the post was saying. BUT, the 71-73 cars dont have the aftermarket kits that work properly.

MOSER engineering at www.moserengineering.com will redrill your rotors to any bolt pattern you want for about $50.00 a pair. Good people.
Tricky Dick