Pinto Car Club of America
Shiny is Good! => General Pinto Talk => Topic started by: davidpinto on November 18, 2022, 04:44:05 PM
WOW JUST PICKED IT UP,AWESOME! $210.00 OUT THE DOOR.PERFECT MATCH ,ALL ALUMINUM WEIGHS JUST 12 LBS,ALL CONNECTIONS ARE CORRECT,IT IS A HIGH FLOW THE TUBES ARE EXTRA LARGE.MY BUDDY AT O'REILLYS ORDERED IT FOR ME . LOOKS LIKE AT LEAST A $600.00 PIECE. JUST PERFECT.IT CAME FROM [ REACH INTL.] IN HIALEAH FLA.PART # IS 41-426 .
Awesome find
Sent from my SM-G965U using Tapatalk
And it's not for some other application, it's actually made for '74-80 Pintos. :D
Their site says '75-80, but I don't think there would be a difference for any factory 2.3/2.8L cars.
And if one is willing/capable to enlarge the cradle opening it should fit the early cars too! It was a few years ago (trying to activate dead memory cells) but basically I removed the 17" radiator and cut out the driver side section. With a little trimming, bending I slid it outward, over the remaining creating a stronger double wall and welded it in place. The top and bottom go behind and the mid-section goes in the indent in front. The 20" radiator touches the bottom valance but a piece of thin rubber separates everything.