Pinto Car Club of America
Welcome to FordPinto.com, The home of the PCCA => Pinto FAQ => Topic started by: yhalkeeiron on February 02, 2014, 12:42:47 AM
Does anybody know if a 79 glass hatch will fit on a 73 run about
Sent from my SPH-L710 using Tapatalk
It will not.
Just curious, what you say it will not fit? I put a 79 bobcat full metal hatch on my 72 that I had years ago. It bolted on just fine. And other than having the holes for Mercury, it was the same.
Maybe it is because the gasket? The early cars, the gasket was glued in where the later ones had to slip over the pinch weld. The glass hatch had a special gasket. He might need to modify the lip to get it to fit.
That is the only think I can think of. In my opinion, the rest of the pieces should bolt in.
I think it should fit fine but a few holes may need drilled depending on the upper hinge & prop shocks. The seal should fit the 73
I just did the swap to my 77 from a 80 doner car all was ez and gained rer defrost it all plugged into the wiring no splicing good luck!!