Been trying to find one. Got one ?
Have you tried a 5.0 fork in it? That fork fit my D9 bell perfectly
You have one you can take measurements from ?
I'll do same with the one I have (need 2 total) tomorrow.
http://www.npdlink.com/store/catalog/Mustang_Clutch_Linkage-6190-1.html
Might work ? I sent them an e-mail.
Off to the shop now....
Summit sells one for 20 bucks. That's where I got mine. Mine is buried in my storage but I did check the fit in my D9 bell a year ago & it was perfect.
http://www.fordpinto.com/pinto-faq/comparison-between-d5-d9-direct-pull-bellhousings/ (http://www.fordpinto.com/pinto-faq/comparison-between-d5-d9-direct-pull-bellhousings/)
http://www.summitracing.com/parts/atp-za125/overview/ (http://www.summitracing.com/parts/atp-za125/overview/)
Cheap !
Ordered it !
;D
Cool 8)
Quote from: Pinto5.0 on June 20, 2013, 10:32:04 PM
http://www.summitracing.com/parts/atp-za125/overview/ (http://www.summitracing.com/parts/atp-za125/overview/)
Same, except made in China.
Never mind the bubbles in the weld on the blue one (will be re-done). Also, that welder will be given back to the neighbor/owner. I bought a new one that works right.
(http://img.photobucket.com/albums/v140/DerrickJB/Yellow%2072/IMG_0241_zpsc608037a.jpg) (http://smg.photobucket.com/user/DerrickJB/media/Yellow%2072/IMG_0241_zpsc608037a.jpg.html)
I knew it would work. Only difference is the hole is larger than the Pinto cable ball but it's an easy fix.
My fix for the blue one was to cut that small piece out of a Pinto fork & weld it in.
You have other ways to fix ?
I got another Pinto fork to cut up....
Most guys just cut a slot in a washer that has a small hole after cupping it with a ball peen hammer & weld it in