Print Page - Parting out 1978 Mustang

Title: Parting out 1978 Mustang
Post by: nemos on April 23, 2013, 02:15:18 PM

I just picked up this 1978 Mustang for the 2.8L engine. Needed a few parts for my crusing wagon so I'll pick over what I want from it.
Is there anything that people want from this car ? Its is rather good shape! clean paperwork. 77,000 Org Km's . Located in Kamloops BC. No glass in the doors, but the carpet does not even have a rip in it. Almost no rust on the car at all. I'd like to sell it as a whole when I am done with it or just start taking more parts off it.

Title: Re: Parting out 1978 Mustang
Post by: dave1987 on April 23, 2013, 08:34:11 PM

Does it have the driver side seat rail with two levers? One is the tilt the other is slide, the tilt looks like a "T" handle. I'm in need of one of those seat brackets. I have one, but the seat slide that bolts to the floor is broken in half on one side.

Title: Re: Parting out 1978 Mustang
Post by: nemos on April 23, 2013, 11:44:41 PM

Dave,

I am away from home for the next 2 weeks. When I get back I'll take a look for you.

Title: Re: Parting out 1978 Mustang
Post by: RichFox on September 25, 2013, 02:48:54 PM

If you still have it and it's an automatic, I need the spacer that I believe goes between the crankshaft and the flexplate. Or everything between the crank and torque converter. 650-345-5221

Title: Re: Parting out 1978 Mustang
Post by: Clydesdale80 on September 25, 2013, 06:18:34 PM

what do u want for the gas tank?

Title: Re: Parting out 1978 Mustang
Post by: 78Mustang on September 26, 2014, 06:54:02 PM

Does it have stick shift pedals? How good are the door panels and front fenders?

Pinto Car Club of America

Welcome to FordPinto.com, The home of the PCCA => Parts Resources, Here is where you can find this or that. => Topic started by: nemos on April 23, 2013, 02:15:18 PM