Print Page - C3 flex plate --question

Title: C3 flex plate --question
Post by: lefty on May 18, 2011, 03:07:43 PM

Does the flex plate look to be mounted properly?
(http://i72.photobucket.com/albums/i171/tom2tones/engine4.jpg)
thanking you guys in advance. I think I mouted it properly but just want to be absolutely sure!

Lefty

Title: Re: C3 flex plate --question
Post by: r4pinto on May 18, 2011, 05:49:39 PM

There should be some type of stamping marking which side goes towards the front & that would be towards the engine block. It looks like it is installed correctly but it has been a while since I installed mine.

Title: Re: C3 flex plate --question
Post by: Fred Morgan on May 18, 2011, 08:19:24 PM

Just pulled this 1 last week. Fred :)

Title: Re: C3 flex plate --question
Post by: lefty on May 18, 2011, 10:15:12 PM

thanks guys after looking at Fred's pic shows same as mine--FYI there were NO stampings indictaing front -back etc nothing. Thanks again..

Lefty

Pinto Car Club of America

Welcome to FordPinto.com, The home of the PCCA => General Help- Ask the Experts... => Topic started by: lefty on May 18, 2011, 03:07:43 PM