Print Page - 2.3 to 2.0 alignment dowl

Title: 2.3 to 2.0 alignment dowl
Post by: prrii on April 08, 2005, 07:44:56 PM

anyone know where to find these bits? got the 2.3 bellhousing and it lines up well, unfortunately the alignment dowl's are different sizes..... someone mentioned offset dowl? Haven't had much luck finding them so far. How about a dowl that is 2 different sizes, looks like the holes have the same center, just different outside diameters

thanks again!
Rob

Title: Re: 2.3 to 2.0 alignment dowl
Post by: 77turbopinto on April 08, 2005, 07:49:04 PM

PM me, I have them.

Bill

Title: Re: 2.3 to 2.0 alignment dowl
Post by: prrii on April 08, 2005, 11:19:48 PM

Appreciate it Bill, I'll drop him a line and see if he's willing :)

Rob

Title: Re: 2.3 to 2.0 alignment dowl
Post by: turbo toy on April 25, 2005, 05:10:16 PM

If you can't find any stepped dowels you can have the dowel holes drilled to 39/64.Thet should be done on a mill to keep the alignment right.Curtis

Title: Re: 2.3 to 2.0 alignment dowl
Post by: turbopinto72 on April 25, 2005, 08:31:43 PM

I used a "tube" with the proper OD of the bell and the proper ( or real close to) the proper ID of the dowl.

Title: Re: 2.3 to 2.0 alignment dowl
Post by: BoostedOne on April 28, 2005, 08:28:10 PM

If you can get the 2.3 dowels out of the block you can have them machined down to the 2.0L diameter. Thats what I did and it worked fine.

Pinto Car Club of America

Shiny is Good! => General Pinto Talk => Topic started by: prrii on April 08, 2005, 07:44:56 PM