Pinto Car Club of America
Shiny is Good! => General Pinto Talk => Topic started by: dusted000 on February 03, 2005, 07:54:24 AM
I have purchased a mustang ministock race car(85) with a 4 speed german trans. It has what looks like a 3 paddle racing clutch 7.5 inch 23 spline, probably from esslinger in it that is bad. I want to replace it with a normal clutch . The flywheel in the racecar is steel but it is approx half the width of a normal mustang with a t5 trans. Im guessing that the flywheel is also aftermarket from possibly esslinger also. Is anyone familiar with the early pinto flywheels like possibly from a 1.6 motor. Could this flywheel be from something stock like this. The throwout bearing is aprox twice as long as a stock mustang clutch setup. Any help would be appreciated as I am trying to figure out what the parts are in this car. thanx. wnk.
Its probably a lightened steel unit. It would not be from a 1.6 engine.