Pinto Car Club of America

 If there is someone on here that is knowledgeable with front
suspension, I NEED HELP!
Since this is a question (crazy at least) that I doubt would be
of use to the other members, perhaps if you are willing to help
it may be best to do it by email. hawker39@verizon.net
Warning I am old and therefore old school stubborn !
Can this work, I need to lower my engine appx. 2" to pass PA
state insp. Cut out my crossmember and space it down from the
frame 2" so to drop engine, then use 2" drop spindles to get back
to near org. ride height? Steering shaft and stut rod brackets
would need mods for sure.
I won't give up my carb set up ! Can't figure how to show pic !
THANKS
T