Pinto Car Club of America
Welcome to FordPinto.com, The home of the PCCA => Parts Resources, Here is where you can find this or that. => Topic started by: 1914pinto on October 23, 2008, 08:18:54 PM
I'm putting a pinto engine into my 1914 model T...I have a 2.3 pinto motor. The intake manifold and carb will NOT fit under my hood. I see advertisements on ebay and such for 2.0 intake manifolds that are very short and even with side draft webers could work. Does anyone know oif the intakes and bolt spacing are the same on the 2.3 and 2.0 heads? Its the head where the two center intakes are round and the ones on the outside ends are oval. Also will the ranger five speed bolt up?
The 2.0 intake will not fit on a 2.3 head. Where is the clearance problem? Is it hight , width both?