Pinto Car Club of America

took some pics of this for dave!! hope it helps with the shape and size!
im sure this is a hard piece to find not all busted up. i dont want to un-bolt mine looks way to easy to breck!!
thanks eric

Thank you so much for taking these photos, I will see what I can do to possibly fabricate something and will keep everyone updated!

dave are you Fabricating these? is so i have one that isnt too Damaged if you need it to base a mold from.

I am definitely looking into it. I am new to the fiberglass fabrication though, so I wouldn't really want to take one of the few in existence off your hands and end up failing at my attempt. I am still experimenting with fabrication, and I think map351 would be a better choice at this point in time.

There was one of those on ebay not that long ago. It did not sell for much at all, maybe 10-20 bucks. I almost bid because it was so cheap.

I have a good spare to use to make a mold, but I don't think the demand for them is high.


Bill

Agghhh....!  I was going to get one of those at the Pick A Part 50% off sale last week. I could probably have had it for $2.  In the end I though it took up too much knee room and the screws were hard to get at - so I let it.  It was VERY clean too.
Tom