Pinto Car Club of America
Shiny is Good! => General Pinto Talk => Topic started by: 77turbopinto on October 10, 2008, 11:21:21 PM
...IF they want to put it in any of the cars mentioned in the auction (other than what it came out of).
At the risk of sounding like a 'know-it-all', I want to post about this ebay item:
http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&ssPageName=STRK:MEWAX:IT&item=280275133922
This cam should fit into any Pinto style 2.3, but the followers are not made for the diameter valve stems that Pintos and all the 2.3Ts have. In other words, it will not be a direct-bolt-in for any 2.3 made before 1995.
Buyerr bewaree.
Bill
Sound advice. Best not to make a mistake if we can avoid it. Sorry if I got off on the wrong foot with you. I picked a sore subject first time out. I did get the information I was looking for though, so I don't entirely regret posting. Hopefully I can contribute something here too, and I'd like to be around for a while.
Regards
Chuck
It was not a sore subject, nor do I think we had any real issues (at least I did not with you). It takes a lot to get under my skin, and you were nowhere near, I hope I was not to you; I just stated my opinion(s) to your question(s). As I mentioned in another thread ("New Topic"), "reading" emotion and/or intent in posts is very hard. Sometimes people "read" that I am upset when I'm not, I'm just very detail oriented in my writing. Sometimes I post too much info, sometimes not enough.
There is no doubt in my mind that you are, and will continue to be and asset to this site.
Bill
Pintony found this one and wants it spread around that its not for any Pinto.
I think it is for a Vega.
http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&ssPageName=STRK:MEWAX:IT&item=180298239323
Bill