Print Page - Hi temp epoxy?

Title: Hi temp epoxy?
Post by: Ironman on August 17, 2008, 02:29:51 AM

Does anyone know of a hi temp epoxy that might be suitable for building an intake manifold?

I know there is something out there cuz I once saw an article about some guy building one for his airplane.

Title: Re: Hi temp epoxy?
Post by: 77turbopinto on August 17, 2008, 07:35:35 AM

MIG

Bill

Title: Re: Hi temp epoxy?
Post by: Ironman on August 17, 2008, 07:59:55 PM

What do you think an Aluminum cylinder head runs at temp wise on the intake side?

Title: Re: Hi temp epoxy?
Post by: dick1172762 on August 17, 2008, 09:20:48 PM

Three Loy is what Mazda uses. You can drill and tap it after it sets up.

Pinto Car Club of America

Shiny is Good! => General Pinto Talk => Topic started by: Ironman on August 17, 2008, 02:29:51 AM