Author Topic: Wagon Trailer Hitch (Read 1216 times)

flash041 · « **on:** June 16, 2018, 03:33:19 PM »

I recently purchased a camper. My old-home made hitch was strong enough, but i need to have the ball higher for the camper to tow level. I was going to fab a receiver hitch from scratch, but thought Id check to see if I could find a new one that would fit with few modifications. After searching online I settled for Curt number 11485, that fits a 2017 Mercedes-Benz C300. I contacted Curt for dimensions, and was confident that it would work.

flash041 · « **Reply #1 on:** June 16, 2018, 03:36:47 PM »

I cut the outer corners as shown. On the right side I shaped one of the pieces I cut off and welded it in the gap that needed to be filled.

flash041 · « **Reply #2 on:** June 16, 2018, 03:41:27 PM »

With the bumper on , I put the itch in place and marked the mounting holes that needed to be drilled. I removed the bumper and drilled the mounting holes.

flash041 · « **Reply #3 on:** June 16, 2018, 03:49:22 PM »

I reinstalled the bumper. Support is needed at the bumper. I decided to use 5 inch long grade 8 bolts instead of welding on the receiver tube. I fabed two plates to keep the bolts together and used hardened washers for spacers. Supporting here is important, other wise the hitch would bend down under load.

flash041 · « **Reply #4 on:** June 16, 2018, 03:54:23 PM »

Once it was done I used a 5 inch ball mount riser to attain the proper height. I also added a seven Pin RV plug and brake controller. The hitch fits Perfectly! Just like it was make for it!

News:

Current Classifieds

Author Topic: Wagon Trailer Hitch (Read 1216 times)

flash041

Wagon Trailer Hitch

flash041

Re: Wagon Trailer Hitch

flash041

Re: Wagon Trailer Hitch

flash041

Re: Wagon Trailer Hitch

flash041

Re: Wagon Trailer Hitch