Current Classifieds

6.6.75 carrier
Date: 02/14/2018 06:47 am
Wanted 2.3 engine mount brackets and mounts
Date: 02/14/2018 01:34 am
WTB: 2.0 Mech tach drive distributor
Date: 04/14/2023 06:15 am
Wanted hood hinges
Date: 02/17/2020 05:30 pm
1975 Ford Pinto

Date: 01/13/2020 11:02 am
Front sump oil pan
Date: 01/02/2017 06:54 pm
71-73 Rear valance panel
Date: 01/14/2021 06:54 pm
74 4 spd and rear axle
Date: 09/26/2018 03:51 pm
Parts Parts Parts
Date: 09/08/2018 03:13 pm
Looking for license plate bracket, interior parts 72' Runabout
Date: 04/12/2017 08:15 am
Need 2.3 timing cover
Date: 08/10/2018 11:41 am
1978 PINTO PONY FOR SALE 17,000 ORIGINAL MILES !!!!!!!
Date: 10/10/2019 10:02 pm

« previous next »
Pages: [1]   Go Down

Author Topic: Finally got off my butt  (Read 1790 times)

0 Members and 1 Guest are viewing this topic.

Offline slowride

  • Pinto Sr. Member
  • ****
  • Posts: 279
  • FeedBack: +18/-0

    • Total Badges: 3
    Badges: (View All)
    Topic Starter Windows User Fifth year Anniversary
Finally got off my butt
« on: November 12, 2011, 11:02:35 AM »
With Winter coming and the occasional rains passing thru, I figured I had better get off my butt and reseal the leaking windshield. I've had everything for months, but Summer gave me an excuse to put it off. Not a particularly HARD job, just messy between using butyl rubber and mineral spirits.
Had a REALLY good rain about 3am and went out to check the floor when I woke up. It's actually dry! It'll be almost like driving a normal car again...... :)
Logged

Offline Pinto5.0

  • Pinto Master
  • *****
  • Posts: 1974
  • FeedBack: +77/-0
  • Gender: Male
  • 80 hatch, 76 Wagon, 72 & 73 Sedans, 71 half hatch

    • Total Badges: 7
    Badges: (View All)
    Topic Starter Signature Poll Voter Mobile User Fifth year Anniversary Windows User 1000 Posts
Re: Finally got off my butt
« Reply #1 on: November 14, 2011, 05:01:20 PM »
Don't forget the wiper post seals leaking or the seals around the heater hoses & blower motor. Then theres the rusty cowl or bad vent seal leaks & the hard as a rock door seals to worry about. My hatch seal was another leaker ugggghhh!!
Logged
'73 Sedan (I'll get to it)
'76 Wagon driver
'80 hatch(Restoring to be my son's 1st car)~Callisto
'71 half hatch (bucket list Pinto)~Ghost
'72 sedan 5.0/T5~Lemon Squeeze

Offline slowride

  • Pinto Sr. Member
  • ****
  • Posts: 279
  • FeedBack: +18/-0

    • Total Badges: 3
    Badges: (View All)
    Topic Starter Windows User Fifth year Anniversary
Re: Finally got off my butt
« Reply #2 on: November 15, 2011, 05:08:33 PM »
I'm pretty lucky in those respects. The windshield wipers don't leak.... the only issue is (of course) door w/strips. Not because they leak water, but wind noise (whistling). Those and the belts moldings will be next, then last.... new carpet. I've been itching for new carpet, but it didn't make sense with a water leak. I've replaced the rear tailgate (wagon) w/strip so that is dry, and have a line on new w/strips for the pop-out windows too.
About the time I get all new rubber installed, it'll be time to start over. Kinda like painting the Golden Gate Bridge....
Logged

Offline slowride

  • Pinto Sr. Member
  • ****
  • Posts: 279
  • FeedBack: +18/-0

    • Total Badges: 3
    Badges: (View All)
    Topic Starter Windows User Fifth year Anniversary
Re: Finally got off my butt
« Reply #3 on: November 16, 2011, 09:22:36 AM »
I also found a vintage set of Cal Custom pedal pads that I just HAD to get. The rain is coming, the old brake pedal pad was worn, safety first.... you know, pick a reason ;)
Oh, and what vehicle was on the installation instructions on the back? Pinto of course.....
Logged

Offline PintoMan1

  • Pinto Sr. Member
  • ****
  • Posts: 400
  • FeedBack: +0/-0
  • Gender: Male

    • Total Badges: 6
    Badges: (View All)
    Tenth year Anniversary Topic Starter Signature Poll Voter Windows User Fifth year Anniversary
Re: Finally got off my butt
« Reply #4 on: November 16, 2011, 09:39:33 AM »
you mentioned that you have a line on new rubber for the pop-out windows would they have them for the pop-out 1/4 windows for the sedan (hatchback)?
 
thanks
Logged
1973 pinto runabout

Offline slowride

  • Pinto Sr. Member
  • ****
  • Posts: 279
  • FeedBack: +18/-0

    • Total Badges: 3
    Badges: (View All)
    Topic Starter Windows User Fifth year Anniversary
Re: Finally got off my butt
« Reply #5 on: November 16, 2011, 10:12:03 AM »
Quote from: pintoman1 on November 16, 2011, 09:39:33 AM
you mentioned that you have a line on new rubber for the pop-out windows would they have them for the pop-out 1/4 windows for the sedan (hatchback)?
 
thanks
That I can't tell you. I had to compare the dimensions and profile of bulk weatherstrips against the factory w/strips. Post a close-up pic of the weatherstrip and I'll see if there's an equivalent.
Logged

Offline D.R.Ball

  • Pinto Sr. Member
  • ****
  • Posts: 558
  • FeedBack: +36/-2
  • Gender: Male

    • Total Badges: 5
    Badges: (View All)
    Topic Starter Tenth year Anniversary Poll Voter Windows User Fifth year Anniversary
Re: Finally got off my butt
« Reply #6 on: November 17, 2011, 11:25:31 AM »
Has anyone tried to use a set of wiper post seals from a 1970's Datsun 240Z ? They are still being made and sold.....
Logged
Pages: [1]   Go Up
« previous next »