PINTO CAR CLUB of AMERICA
Shiny is Good! => General Pinto Talk => Topic started by: pinto_one on January 27, 2017, 02:28:16 PM
-
Just got in some new parts for my pinto , new 3.40 gear set and a yukon HD posi unit along with a overhaul bearing kit , thought about posting the steps on assembly of the third member if anyone thinks it a good idea , Later Blaine
-
Great idea! Go for it!
-
Yes please, I am currently struggling thru an 8.8 rebuild. Might learn something new from you LOL.....
-
Great idea, go for it..
-
Well got some progress today, took one of my spare third member from a rear end and cleaned it up , along with the axles , installing new bearings there also along with the seals , bead blasted and painted up the unit and installed the pinnion nose bearing in the case , mounted the ring gear to theposi unit with new bolts , a dab of lock tight on each and torque to 60LBS , droped the carrier into place and and install caps , they also torque to 60 also , would have done more but forgot the pinnion shims at home so guess it will have to wait
-
Looks good.
-
Tomorrow I will be finishing it up and posting more photos , hopefully this weekend I will install it ;D
-
got it all together , installed new pinnion bearings and a new crush sleave , which is a must for correct pinnion preload , which 10 to 14 inch pounds to turn the pinnion , sorry for fuzzy photo there , but you get the idea ,
-
after I got the pinnion tourqe done with I reinstalled the carrrer and shimed the pinnion gear to have the right gear contact , the pattern will end up like this when you have the back lash right and the right shim in place , after I recheck all the bolts for correct tourqe , the five pinnion bolts (3/8 ) 45 ft lbs , carrer bearing caps 60 ft lbs , the ring gear also 60 lbs , now all complete , next I will post changing of the axle bearings , next project is assmbling a cust 520 cubic inch 6 cylinder aircraft engine ,