Current Classifieds

74 hood
Date: 07/03/2017 03:46 pm
2.3 front sump oil pan
Date: 07/24/2018 03:17 pm
Pinto drive train

Date: 06/29/2018 08:32 am
1971 Pinto (survivor)

Date: 05/15/2022 04:42 pm
instrument cluster,4sd trans crossmember,2.3 intake
Date: 08/26/2018 06:23 pm
Needed- Good 71-73 Rear End or parts- close to AL
Date: 09/15/2019 12:38 pm
1970-1973 British 4 Speed Manual; Parts or Whole
Date: 03/17/2019 03:57 am
74 Pinto Rear Side Lights

Date: 02/18/2017 05:47 pm
Wanted 2.3 engine mount brackets and mounts
Date: 02/14/2018 01:34 am
13" Style Steel Trim Rings

Date: 10/09/2020 10:35 pm
13x6 minilite style wheels MAKE OFFER——NEED GONE

Date: 08/01/2018 01:17 pm
79 pinto steering column
Date: 08/18/2018 02:00 pm

Author Topic: Lowering my Pinto Panel  (Read 1970 times)

0 Members and 1 Guest are viewing this topic.

pintoperformance

  • Guest
Lowering my Pinto Panel
« on: February 09, 2004, 11:33:22 PM »
 ;Djust finished getting my Pinto Panel off the jack stands and back on the ground ((WOW)) I used 3 inch lowering blockfor the back and cut the front springs,,,

Lowered the car a total of 3 1/2 in front and 3 inches in back...

When I am standing in front of the front bumper it hits me just below my knees (I am 5'9) and when standing in back of the panel the top hits me just about mid chest..

took it on a test run and everything clears--turning radius is not affected....

When the ground effects the Panel has a real nice lowered stance...

Will have pics as soon as I can and then will post them..

Mike