Current Classifieds

77 Cruising wagon Rear cargo light
Date: 10/02/2017 02:16 pm
Leaf Spring Mount Rubber Insulator
Date: 08/05/2018 01:58 pm
Pinto brake booster needed
Date: 05/08/2021 09:00 am
75 wagon need parts
Date: 05/28/2020 05:19 pm
'80 Pinto Wagon
Date: 02/01/2018 05:20 pm
Clutch pedal needed
Date: 01/11/2024 06:31 am
Looking for leaf spring insulators
Date: 04/04/2020 09:38 am
Need Brakes for 1971 Pinto
Date: 04/27/2018 11:48 pm
ENGINE COMPLETE 1971 PINTO
Date: 12/28/2017 03:55 pm
72 Pinto
Date: 03/07/2019 12:07 pm
Need hatchback fuel tank sending unit
Date: 08/13/2018 02:46 pm
1974 Wiring diagram free
Date: 10/27/2019 06:56 pm

« previous next »
Pages: [1]   Go Down

Author Topic: BIG improvement in performance!  (Read 806 times)

0 Members and 1 Guest are viewing this topic.

Offline fastfred

  • Pinto Member
  • **
  • Posts: 76
  • FeedBack: +3/-0
  • Gender: Male
  • Pinto running gear. Mercedes Gazelle

    • Total Badges: 5
    Badges: (View All)
    Tenth year Anniversary Topic Starter Mobile User Windows User Fifth year Anniversary
BIG improvement in performance!
« on: May 16, 2018, 11:11:04 AM »
My car is powered by a 1977 2.4 Pinto motor. 3 speed auto.   It has the Holley twin choke carb. Several years ago I put the secondary main jet in the primary and with a jet drill opened the jet i put in the secondary choke. A decent improvement straight away.  Since then I have been shimming the linkage so that the secondary butterfly opens earlier.
 It is supposed to open when the primary opens when it is at 45 degrees.  I have it opening earlier and what a difference in pickup!  This happens from lows revs all the way through! At low throttle openings/cruising speeds the secondary is still closed but when I put my foot down the secondary kicks in and the car accelerates so much better.  This happens without the trans. changing from high gear. Big difference at even 2000 rpm in high gear. Probably uses more gas but the car is not my daily driver!

Fred
Logged

Offline Wittsend

  • Pinto Master
  • *****
  • Posts: 2498
  • FeedBack: +241/-0

    • Total Badges: 8
    Badges: (View All)
    Tenth year Anniversary Mobile User Topic Starter Poll Voter 1000 Posts Linux User Windows User Fifth year Anniversary
Re: BIG improvement in performance!
« Reply #1 on: May 17, 2018, 11:50:48 AM »
Might try advancing the ignition timing a little at a time too.  A lot of those cars had the timing retarded for smog reasons.  Maybe cam timing too. My daily drive is a 2000 Mazda Protege.  I advanced the ignition timing 4 degrees and the intake cam 3 degrees. It cost me nothing but my time and since I was replacing cam seals I was "in there" anyway.  All it took was filing (elongating) holes in the ignition reluctor and the cam pin hole.

While not the same method for your engine these mods made the car far "crisper" than it was before.
Logged
Pages: [1]   Go Up
« previous next »