« previous next »
Pages: [1]   Go Down

Author Topic: vacuum line diagram  (Read 936 times)

0 Members and 1 Guest are viewing this topic.

Offline lmgoldstein

  • Pinto Driver
  • *
  • Posts: 1
  • FeedBack: +0/-0
  • Another Pinto Driver

    • Total Badges: 1
    Badges: (View All)
    Topic Starter
vacuum line diagram
« on: September 17, 2016, 11:01:46 PM »
I have a Pinto Engine 2.0 I think.  It is sitting in my M38a1 Willys Jeep.  Long story short I have this vacuum line.  It connects where I am pointing my screw driver.  Anybody knows where it goes?  Thanks
Logged

Offline robertwwithee

  • Pinto Full Member
  • ***
  • Posts: 228
  • FeedBack: +4/-0
  • Another Pinto Driver

    • Total Badges: 2
    Badges: (View All)
    Mobile User Topic Starter
Re: vacuum line diagram
« Reply #1 on: September 22, 2016, 03:44:49 PM »
U do have a 2 liter and I never seen a vacuum advance with 2 ports on it.  Possibly 1974 2.0 dizzy?

Sent from my SPH-L720T using Tapatalk

Logged

Offline Wittsend

  • Pinto Master
  • *****
  • Posts: 2499
  • FeedBack: +241/-0

    • Total Badges: 8
    Badges: (View All)
    Tenth year Anniversary Mobile User Topic Starter Poll Voter 1000 Posts Linux User Windows User Fifth year Anniversary
Re: vacuum line diagram
« Reply #2 on: September 22, 2016, 08:09:18 PM »
Usually the second vacuum port on a vacuum module is to retard the ignition for smog purposes. Typically there was for lack of a better term a manual "computer" that sent manifold vacuum and coolant temperature and controlled when the retarding occurred through relays and solenoids. Doing so (retarding the ignition) will hurt power and mileage. I'm guessing the previous owner did not install it - all to the engines betterment.
Logged
Pages: [1]   Go Up
« previous next »