Current Classifieds

'72 Runabout Drivers Side Door Hinge Set
Date: 12/15/2018 02:21 am
1976 Ford Pinto

Date: 07/16/2019 02:51 am
Pinto Vinyl Top

Date: 10/09/2020 10:29 pm
Wanted - Offenhauser intake for 2.8l (6097DP)
Date: 01/28/2019 05:15 pm
wanted a 1979 Pinto or Bobcat front valance
Date: 03/17/2019 10:15 pm
Ford 2.3 Bellhousing C4/C5 & Torque Converter

Date: 07/08/2022 11:51 pm
Need '75 Pinto wagon front seat belt assembly housing
Date: 10/03/2018 10:46 pm
Hatch needed
Date: 09/10/2017 09:16 pm
1976 Pinto

Date: 10/24/2017 02:00 pm
1977 Pinto Cruizin Wagon

Date: 04/11/2024 03:56 pm
Wanted hood hinges
Date: 02/17/2020 05:30 pm
1978 hatch back

Date: 11/29/2019 03:18 pm

Author Topic: Using stock fan on a Turbo SVO 2.3 motor  (Read 853 times)

0 Members and 1 Guest are viewing this topic.

Offline biggrgivens

  • Pinto Member
  • **
  • Posts: 43
  • FeedBack: +2/-0
  • Another Pinto Driver

  • Total Badges: 3
    Badges: (View All)
    Topic Starter Mobile User Windows User
Using stock fan on a Turbo SVO 2.3 motor
« on: July 01, 2014, 11:47:44 PM »
Going to start putting the 2.3 turbo engine together with pinto essentials. Question....I would like to use the shortest water pump there is, so that I can continue to use the stock fan. What pump can I use on a turbo 2.3 motor that will allow me to continue to use the stock fan setup?


Offline Wittsend

  • Pinto Master
  • *****
  • Posts: 2499
  • FeedBack: +241/-0

  • Total Badges: 8
    Badges: (View All)
    Tenth year Anniversary Mobile User Topic Starter Poll Voter 1000 Posts Linux User Windows User Fifth year Anniversary
Re: Using stock fan on a Turbo SVO 2.3 motor
« Reply #1 on: July 02, 2014, 11:07:41 AM »
I'm thinking there is no shortest water pump.  Remember the water pump pulley has to align with crank pulley. If your car is '74 and up you should have sufficient space already. If you put the 2.3 in a '71-'73 there is minimal space. I think there is about 3/16" between the bolt and the center rod in the picture.  I run an electric fan without issues. I use the whole Turbo Coupe relay box. The fan is basically generic with a mount made from angle iron. My only issue is fingers and fans. thankfully the fans don't run with the engine off.  Here are a few pictures.


Offline amc49

  • PCCA VIP
  • Pinto Master
  • ***
  • Posts: 1256
  • FeedBack: +242/-1
  • Another Pinto Driver

  • Total Badges: 4
    Badges: (View All)
    Topic Starter Poll Voter Windows User 1000 Posts
Re: Using stock fan on a Turbo SVO 2.3 motor
« Reply #2 on: July 02, 2014, 12:36:36 PM »
Yah, long or short, that pulley must line up, then you mod fan spacing itself and separately.