Current Classifieds

Wanted 2.3 engine mount brackets and mounts
Date: 02/14/2018 01:34 am
Looking for license plate bracket, interior parts 72' Runabout
Date: 04/12/2017 08:15 am
Wanted 73 pinto squire wagon
Date: 05/09/2020 11:59 am
Weather Strip, Muffler, Splash Shields

Date: 02/21/2022 11:11 pm
hood for a 79-80
Date: 11/30/2018 10:55 pm
Wanted - Offenhauser intake for 2.8l (6097DP)
Date: 01/28/2019 05:15 pm
cam pulley
Date: 05/30/2018 04:56 pm
1979 Runabout Rear Panel
Date: 01/04/2020 02:03 pm
1980 Pinto Wagon

Date: 02/29/2020 07:01 pm
WTB: 2.0 Mech tach drive distributor
Date: 04/14/2023 06:15 am
Need Brakes for 1971 Pinto
Date: 04/27/2018 11:48 pm
Custom Pinto Project

Date: 06/12/2016 07:37 pm

Author Topic: turbo ranger stumble off idle and at 5psi?  (Read 1213 times)

0 Members and 1 Guest are viewing this topic.

Offline 2point3turbo

  • Pinto Full Member
  • ***
  • Posts: 216
  • FeedBack: +1/-0
  • Gender: Male

  • Total Badges: 5
    Badges: (View All)
    Topic Starter Signature Tenth year Anniversary Windows User Fifth year Anniversary
turbo ranger stumble off idle and at 5psi?
« on: March 28, 2015, 12:58:01 PM »
Have timing set at 10*
new knock sensor
new IAC
inline electric pump- plenty of pressure at fuel rail.

Motor idles well but will buck under just open throttle.
will run and build boost well under quarter throttle until just at 5psi
then it starts the same fall on face loss of power and bucking.

any ideas on cause? possible bad wastegate blowby?
vacuum leak?
Must have more POWER!!!! Gimmee Gimmee Gimmee!!

Offline 2point3turbo

  • Pinto Full Member
  • ***
  • Posts: 216
  • FeedBack: +1/-0
  • Gender: Male

  • Total Badges: 5
    Badges: (View All)
    Topic Starter Signature Tenth year Anniversary Windows User Fifth year Anniversary
Re: turbo ranger stumble off idle and at 5psi?
« Reply #1 on: March 28, 2015, 08:33:46 PM »
Well it ended up being the wastegate actuator.


The motor actually had a tiny little Warner Ishi turbo on it so that wasnt helping it at all either. We replaced it with a Garrett T3 and it runs fine now. Just have a bit of detonation at 15psi but we will get that straightened out soon.
Must have more POWER!!!! Gimmee Gimmee Gimmee!!

Online dga57

  • Chief Moderator / Admin
  • FordPinto.com Moderator
  • Pinto PooBAH
  • ***
  • Posts: 7092
  • FeedBack: +208/-0
  • Gender: Male

  • Total Badges: 8
    Badges: (View All)
    Tenth year Anniversary Topic Starter Signature Poll Voter Mobile User Windows User 1000 Posts Fifth year Anniversary
Re: turbo ranger stumble off idle and at 5psi?
« Reply #2 on: March 28, 2015, 10:16:50 PM »
Always good to hear of someone's success!!!


Dwayne :)
Pinto Car Club of America - Serving the Ford Pinto enthusiast since 1999.