Current Classifieds

Pinto Fiber Glass Body Parts
Date: 01/06/2019 06:53 pm
Looking for license plate bracket, interior parts 72' Runabout
Date: 04/12/2017 08:15 am
1978 PINTO PONY FOR SALE 17,000 ORIGINAL MILES !!!!!!!
Date: 10/10/2019 10:02 pm
78 hatchback

Date: 03/12/2023 06:50 pm
72 Turbo Pinto "Hot Rod" rebuild
Date: 08/09/2018 11:09 am
GRILLE NEEDED '71,'72,'73 for a '73 Pinto
Date: 02/10/2017 09:30 am
1973 Pangra

Date: 01/06/2015 02:19 pm
1973 Pangra

Date: 01/06/2015 02:19 pm
pinto parts for sale
Date: 07/25/2018 04:51 pm
Rally spoiler wanted
Date: 05/04/2017 01:32 pm
EARLY PINTO CLUTCH PEDAL ASSEMBLY
Date: 02/14/2019 06:27 pm
WANTED: Skinny Rear Bumper w/o guards for '71 or '72 Pinto Coupe
Date: 04/24/2018 11:45 am

Author Topic: turbo ranger stumble off idle and at 5psi?  (Read 1210 times)

0 Members and 1 Guest are viewing this topic.

Offline 2point3turbo

  • Pinto Full Member
  • ***
  • Posts: 216
  • FeedBack: +1/-0
  • Gender: Male

  • Total Badges: 5
    Badges: (View All)
    Topic Starter Signature Tenth year Anniversary Windows User Fifth year Anniversary
turbo ranger stumble off idle and at 5psi?
« on: March 28, 2015, 12:58:01 PM »
Have timing set at 10*
new knock sensor
new IAC
inline electric pump- plenty of pressure at fuel rail.

Motor idles well but will buck under just open throttle.
will run and build boost well under quarter throttle until just at 5psi
then it starts the same fall on face loss of power and bucking.

any ideas on cause? possible bad wastegate blowby?
vacuum leak?
Must have more POWER!!!! Gimmee Gimmee Gimmee!!

Offline 2point3turbo

  • Pinto Full Member
  • ***
  • Posts: 216
  • FeedBack: +1/-0
  • Gender: Male

  • Total Badges: 5
    Badges: (View All)
    Topic Starter Signature Tenth year Anniversary Windows User Fifth year Anniversary
Re: turbo ranger stumble off idle and at 5psi?
« Reply #1 on: March 28, 2015, 08:33:46 PM »
Well it ended up being the wastegate actuator.


The motor actually had a tiny little Warner Ishi turbo on it so that wasnt helping it at all either. We replaced it with a Garrett T3 and it runs fine now. Just have a bit of detonation at 15psi but we will get that straightened out soon.
Must have more POWER!!!! Gimmee Gimmee Gimmee!!

Offline dga57

  • Chief Moderator / Admin
  • FordPinto.com Moderator
  • Pinto PooBAH
  • ***
  • Posts: 7092
  • FeedBack: +208/-0
  • Gender: Male

  • Total Badges: 8
    Badges: (View All)
    Tenth year Anniversary Topic Starter Signature Poll Voter Mobile User Windows User 1000 Posts Fifth year Anniversary
Re: turbo ranger stumble off idle and at 5psi?
« Reply #2 on: March 28, 2015, 10:16:50 PM »
Always good to hear of someone's success!!!


Dwayne :)
Pinto Car Club of America - Serving the Ford Pinto enthusiast since 1999.