Current Classifieds

Wanted Pinto Fiberglass Body Parts
Date: 05/19/2018 04:56 pm
Wanted hood hinges
Date: 02/17/2020 05:30 pm
1976 Squire wagon

Date: 09/12/2018 10:30 pm
77 Cruising wagon Rear cargo light
Date: 10/02/2017 02:16 pm
73 actuator for heater blend door
Date: 09/19/2019 04:43 pm
Accelerator Pump Diaphram for 1978 Pinto
Date: 09/03/2018 08:58 am
Gas Tank Sending Unit
Date: 05/22/2018 02:17 pm
nos core support

Date: 01/03/2020 09:39 pm
I'm looking for a 78 or older Pinto near Alberta
Date: 08/13/2021 10:39 am
71 72 front bumper brackets
Date: 06/10/2020 10:55 am
1973 Interior parts wanted
Date: 01/02/2017 11:02 pm
Trailer Hitch - 73 Pinto Wagon
Date: 02/04/2018 08:26 am

Author Topic: Towing my pinto  (Read 1927 times)

0 Members and 1 Guest are viewing this topic.

Offline delizious

  • Pinto Member
  • **
  • Posts: 82
  • FeedBack: +0/-0
  • Gender: Female

  • Total Badges: 4
    Badges: (View All)
    Topic Starter Signature Windows User Fifth year Anniversary
Towing my pinto
« on: March 29, 2013, 01:52:36 PM »
So I'm trying to get my car and I down to Georgia and I was wondering if you guys think a Ford E150 cargo van would be able to tow my car with a trailer hitch? I think as I remember someone saying that you have to disconnect some sort of cable?
Lost 1972 Ford Pinto
Gained 1978 Ford Pinto

Offline ToniJ1960

  • Pinto Sr. Member
  • ****
  • Posts: 544
  • FeedBack: +13/-0
  • Gender: Female
  • Another Pinto Driver

  • Total Badges: 5
    Badges: (View All)
    Tenth year Anniversary Topic Starter Poll Voter Fifth year Anniversary Windows User
Re: Towing my pinto
« Reply #1 on: March 29, 2013, 02:50:29 PM »
 I think they mean disconnect the driveshaft that connects the transmission to the rear end of the car. If you tow it with the rear on the ground. Or you could just tow it with the rear end up. But I guess what hapens is if the rear wheels are on the ground and the driveshaft is connected the wheels will make the driveshaft and parts inside the transmission turn too fast, unless youre going to drive no more than 30 or 35 mph.

 Im not sure why they dont just town them in 4th gear Im sure someone will explain it better than I can.

 

Offline tbucketjack

  • Pinto Full Member
  • ***
  • Posts: 107
  • FeedBack: +0/-0
  • Gender: Male

  • Total Badges: 6
    Badges: (View All)
    Topic Starter Poll Voter Linux User Mobile User Windows User Fifth year Anniversary
Re: Towing my pinto
« Reply #2 on: March 29, 2013, 03:49:28 PM »
With Class III frame hitch you could pull the pinto on a Tow Dolly or use a tow bar. If the rear wheels are on the ground, you most likely will have to disconnect the drive shaft. As for using a trailer, brakes are a must on the trailer and the law in most states.

Offline Cookieboystoys

  • Eater of Cookies
  • PCCA Management Board
  • Pinto Master
  • ******
  • Posts: 2253
  • FeedBack: +59/-1
  • Gender: Male
  • It's All About The Pinto's! Baby!
    • Cookieboy's Toys on Facebook

  • Total Badges: 9
    Badges: (View All)
    Tenth year Anniversary Signature Topic Starter Poll Voter Photographer Windows User 1000 Posts Webmaster Fifth year Anniversary
Re: Towing my pinto
« Reply #3 on: March 29, 2013, 04:36:14 PM »
you only have to drop the drive shaft if you are using a 2-wheel dolly and have an auto trans in the Pinto. If it's a manual trans just put it in neutral. The reason you should pull the drive shaft on an auto if using a 2-wheel dolly is that the trans will heat up as the rear wheels turn and no fluid will be pumping thru to cool it and ruin the auto. You can get away with using a 2-wheel dolly on an auto trans but only if you keep the speed low (under 30mph) and only for a very short distance. While some will say tow it backwards with a 2 wheel dolly and auto trans... that really is not recommended.

As for car trailers... class III hitch required. Without specs on the van (year and motor) hard to say if it will be strong enough. Also depends on the trailer and it's weight... the U-Haul car transports are really heavy and have surge brakes (nice) but again they are pretty heavy. A standard car trailer that most people own are usually much lighter but if they have brakes you usually have to have a brake controller wired up for the brakes to work.
It's all about the Pintos! Baby!

Offline delizious

  • Pinto Member
  • **
  • Posts: 82
  • FeedBack: +0/-0
  • Gender: Female

  • Total Badges: 4
    Badges: (View All)
    Topic Starter Signature Windows User Fifth year Anniversary
Re: Towing my pinto
« Reply #4 on: March 29, 2013, 05:11:44 PM »
Yea I don't own a dolly :( I just have a towing hitch and my car is automatic not manual so I guess that's going to be a problem. Not sure how much it costs to rent a dolly/tow bar from somewhere, and I don't know how to disconnect the drive shaft. All the wiring is there on the van to connect to the Pinto I believe so I'm half way to what I need to acquire. Thanks for the information guys your the best!
Lost 1972 Ford Pinto
Gained 1978 Ford Pinto